Share with friends:
Diagnostics of malfunctions of car Mitsubishi Galant 5
Engine Troubleshooting
1. The engine does not turn over when trying to start 1. The battery terminals are loose or corroded. Tighten the terminals and remove the corrosion. 2. The battery is...
1. The engine does not turn over when trying to start 1. The battery terminals are loose or corroded. Tighten the terminals and remove the corrosion. 2. The battery is...
Troubleshooting the engine electrical system
16. The battery is running low 1. Damage or incorrect adjustment of the alternator drive belt ( see Chapter 1 ). 2. Low electrolyte level or battery is discharged ( see...
16. The battery is running low 1. Damage or incorrect adjustment of the alternator drive belt ( see Chapter 1 ). 2. Low electrolyte level or battery is discharged ( see...
Fuel system troubleshooting
19. Increased fuel consumption 1. Air filter is dirty or clogged ( see Chapter 1 ). 2. Incorrect setting of ignition timing ( see Chapter 1 ). 3. Sticking of the air...
19. Increased fuel consumption 1. Air filter is dirty or clogged ( see Chapter 1 ). 2. Incorrect setting of ignition timing ( see Chapter 1 ). 3. Sticking of the air...
Troubleshooting the cooling system
21. Overheating 1. Insufficient amount of coolant in the system ( see Chapter 1 ). 2. The water pump drive belt is damaged or incorrectly adjusted ( see Chapter 1 ). 3....
21. Overheating 1. Insufficient amount of coolant in the system ( see Chapter 1 ). 2. The water pump drive belt is damaged or incorrectly adjusted ( see Chapter 1 ). 3....
Troubleshooting Clutch Problems
27. The clutch does not disengage (the pedal goes to the floor - the gearshift lever does not freely move into the reverse position) 1. Leakage in the hydraulic system...
27. The clutch does not disengage (the pedal goes to the floor - the gearshift lever does not freely move into the reverse position) 1. Leakage in the hydraulic system...
Troubleshooting a Manual Transmission
32. Noise in neutral gear with the engine running 1. Input shaft bearing wear. 2. Damage to the main gear bearing. 3. Wear of intermediate shaft bearings. 4. Wear or...
32. Noise in neutral gear with the engine running 1. Input shaft bearing wear. 2. Damage to the main gear bearing. 3. Wear of intermediate shaft bearings. 4. Wear or...
Automatic transmission troubleshooting
Note: Due to the complexity of the automatic transmission design, it is difficult for an amateur mechanic to properly diagnose and service this unit. In case of...
Note: Due to the complexity of the automatic transmission design, it is difficult for an amateur mechanic to properly diagnose and service this unit. In case of...
Troubleshooting Drive Shafts
42. Clicking sounds when rotating Worn or damaged outer constant velocity joints. Check seal integrity. Replace if necessary ( see Chapter 8 ). 43. Knocking or dull...
42. Clicking sounds when rotating Worn or damaged outer constant velocity joints. Check seal integrity. Replace if necessary ( see Chapter 8 ). 43. Knocking or dull...
Rear Axle Troubleshooting
45. Noise 1. Road noise. No procedures for elimination are provided. 2. Tire noise. Inspect tires and check pressure ( see Chapter 1 ). 3. Wear, damage or increased play...
45. Noise 1. Road noise. No procedures for elimination are provided. 2. Tire noise. Inspect tires and check pressure ( see Chapter 1 ). 3. Wear, damage or increased play...
Troubleshooting the brake system
Note: Before assuming that the brake system is faulty, make sure that the front wheel alignment is correct and that the vehicle is loaded evenly. 46. When braking, the...
Note: Before assuming that the brake system is faulty, make sure that the front wheel alignment is correct and that the vehicle is loaded evenly. 46. When braking, the...
Troubleshooting suspension and steering
53. The car pulls to the side 1. Uneven tire pressure ( see Chapter 1 ). 2. Tire damage ( see Chapter 1 ). 3. Increased wear of the suspension or steering components (...
53. The car pulls to the side 1. Uneven tire pressure ( see Chapter 1 ). 2. Tire damage ( see Chapter 1 ). 3. Increased wear of the suspension or steering components (...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar materials for other Mitsubishi models
➤ Chassis and running gear: Chassis malfunctions Mitsubishi Colt 4 and 5 (1991-2003)
➤ General information: Troubleshooting Mitsubishi Pajero 4 (2006-2021)
Link in different formats to this section
TEXTHTMLBB Code
- General information
- Introduction to guide
- User manual
- Driving and operation
- Maintenance
- Power unit
- Dismantling the engine
- Engine overhaul
- Cooling and heating
- Power and exhaust systems
- Engine electrical equipment
- Engine management systems
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch
- Drive shafts and transfer case
- Chassis and running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Wiring diagrams Galant
- Wiring diagrams Mirage
- Wiring diagrams Diamante
- General information
- Troubleshooting
- Maintenance
- Power unit
- Engine repair
- Engine overhaul
- Cooling and heating
- Fuel and exhaust system
- Engine electrical equipment
- Reducing exhaust toxicity
- Transmission
- Manual gearbox
- Automatic gearbox
- Clutch and drive shafts
- Chassis and running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical diagrams

