Share with friends:
Automatic transmission of car Mitsubishi Galant 5
Automatic transmission — specification
Gaps End clearances of the adjusting sleeve of the gear selector lever with the lever Galant - from 15.2 to 15.0 mm All others 1986 and earlier models - 17.2 to 17.9 mm...
Gaps End clearances of the adjusting sleeve of the gear selector lever with the lever Galant - from 15.2 to 15.0 mm All others 1986 and earlier models - 17.2 to 17.9 mm...
General information
The vehicles covered in this manual have a 4-speed or 5-speed manual transmission or a 3-speed or 4-speed automatic transmission. Information about the automatic...
The vehicles covered in this manual have a 4-speed or 5-speed manual transmission or a 3-speed or 4-speed automatic transmission. Information about the automatic...
Diagnostics — General
Note: Automatic transmission failure can be attributed to five main causes: poor engine performance, incorrect adjustment, hydraulic failure, mechanical failure, or...
Note: Automatic transmission failure can be attributed to five main causes: poor engine performance, incorrect adjustment, hydraulic failure, mechanical failure, or...
Replacing the cuffs
1. Oil leaks are often caused by wear on the differential side drive shaft seals and/or the speedometer drive pinion seal and O-rings. Replacing these seals is...
1. Oil leaks are often caused by wear on the differential side drive shaft seals and/or the speedometer drive pinion seal and O-rings. Replacing these seals is...
Gearbox Mounting Assemblies — Checking and Replacing
1. Insert a large screwdriver or pry bar between the mount and the transmission and try to pry it out. 4.1 To check the movement, try to press the gearbox mounting unit...
1. Insert a large screwdriver or pry bar between the mount and the transmission and try to pry it out. 4.1 To check the movement, try to press the gearbox mounting unit...
Mode selector lever mechanism — removal, installation and adjustment
1. Disconnect the negative battery cable. 2. Working in the engine compartment, remove the air cleaner assembly (if this will make access easier), then disconnect the...
1. Disconnect the negative battery cable. 2. Working in the engine compartment, remove the air cleaner assembly (if this will make access easier), then disconnect the...
Throttle Cable (TV) (3-Speed Models) — Checking and Adjusting
1. For the correct operation of the gearbox, adjusting the throttle cable is very important. The cable controls a valve inside the gearbox that controls the gearshift,...
1. For the correct operation of the gearbox, adjusting the throttle cable is very important. The cable controls a valve inside the gearbox that controls the gearshift,...
Neutral gear sensor — checking, replacing and adjusting
Examination 1. Try to start the car in each gear, the starter should work only in neutral or park position. Replacement 2. Remove the battery and, on fuel-injected...
Examination 1. Try to start the car in each gear, the starter should work only in neutral or park position. Replacement 2. Remove the battery and, on fuel-injected...
Automatic transmission — removal and installation
Removal 1. Disconnect the battery cables, remove the battery and oil pan. On fuel injected models, remove the air cleaner assembly. 2. Raise the vehicle and place it on...
Removal 1. Disconnect the battery cables, remove the battery and oil pan. On fuel injected models, remove the air cleaner assembly. 2. Raise the vehicle and place it on...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar materials for other Mitsubishi models
➤ Transmission: Automatic gearbox Mitsubishi Colt 2 and 3 (1983-1993)
➤ Transmission: Automatic gearbox Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Transmission: Automatic gearbox Mitsubishi Outlander 1 (2003-2008)
➤ Transmission: Automatic gearbox Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Transmission: Automatic gearbox Mitsubishi Space Star (1998-2005)
Link in different formats to this section
TEXTHTMLBB Code
- General information
- Introduction to guide
- User manual
- Driving and operation
- Maintenance
- Power unit
- Dismantling the engine
- Engine overhaul
- Cooling and heating
- Power and exhaust systems
- Engine electrical equipment
- Engine management systems
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch
- Drive shafts and transfer case
- Chassis and running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Wiring diagrams Galant
- Wiring diagrams Mirage
- Wiring diagrams Diamante
- General information
- Troubleshooting
- Maintenance
- Power unit
- Engine repair
- Engine overhaul
- Cooling and heating
- Fuel and exhaust system
- Engine electrical equipment
- Reducing exhaust toxicity
- Transmission
- Manual gearbox
- Automatic gearbox
- Clutch and drive shafts
- Chassis and running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical diagrams

