Clutch and drive shafts of car Mitsubishi Galant 5

Clutch and Drive Shafts — Specification
Clutch Free pedal travel - See Chapter 1 Minimum clutch disc lining thickness is 0.3 mm above rivet heads Drive shafts Length of internal constant velocity joints in...

General information
This chapter describes the parts from the rear of the engine to the front wheels, except for the transmission, which is described in previous chapter . For ease of...

Clutch — description and testing
1. All vehicles with a manual transmission have a single-plate dry clutch with a diaphragm spring (see illustration). The driven clutch disc has a toothed sleeve sliding...

Clutch parts — removal, inspection and installation
Warning: Clutch wear dust that settles on clutch components contains asbestos, which is hazardous to health. Do not blow off this dust with compressed air or inhale it....

Clutch release bearing, release fork and axle — removal and installation
Warning: Clutch wear dust that settles on clutch components contains asbestos, which is hazardous to health. Do not blow off this dust with compressed air or inhale it....

Clutch cable — removal, installation and adjustment
Removal 1. Disconnect the negative battery cable (ground). 2. Completely unscrew the adjustment wheel to loosen the cable tension. 3. Remove the cotter pin from the...

Clutch Master Cylinder — Removal, Overhaul and Installation
Removal 1. Disconnect the cable from the negative battery terminal. 2. Under the front panel, disconnect the push rod from the upper end of the clutch pedal. It is...

Clutch slave cylinder — removal, overhaul and installation
1. Disconnect the hydraulic pipes from the slave cylinder and plug the end of the pipe to prevent fluid from leaking. 2. Remove the cotter pin (if any). 3. Unscrew the...

Clutch hydraulic system — bleeding
1. The hydraulic system should be bled until all air is removed if any part of the system has been removed or if the fluid level in the clutch master cylinder reservoir...

Drive shafts — general information and testing
Power is transmitted from the transmission to the wheels via two drive shafts. The inner end of each drive shaft is splined into the differential. The outer ends of the...

Drive shafts — removal and installation
Removal 1. Apply the parking brake, remove the wheel cover and loosen the hub nut. Loosen the front wheel nuts, lift the car and place it on stable stands. Remove the...

Replacement of drive shaft covers and overhaul of constant velocity joint
Inner constant velocity joint and cover Double offset joint (DOJ) Disassembly 1. Remove the drive shaft from the vehicle ( see section 10 ). 2. Secure the drive shaft in...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Transmission: Clutch and drive shafts Mitsubishi Colt 5 (1995-2003, petrol)
➤ Transmission: Clutch Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Transmission: Clutch Mitsubishi L200 4 (2005-2014, diesel)
➤ Transmission: Clutch Mitsubishi Outlander 1 (2003-2008)
➤ Transmission: Clutch Mitsubishi Pajero 4 (2006-2021)
➤ Transmission: Clutch Mitsubishi Space Star (1998-2005)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code