The parts are removed in the order shown in the figure.
Installation of parts is carried out in the reverse order of removal.
When removing parts, pay attention to the operation of removing the side turn signal. Using a special tool, pry the side turn signal and remove it from the front wing panel.
Checking the front fog light and rear fog light switches
Check the condition of the circuit between the terminals of the switch connector at different positions of the switch according to the table provided.
Switch Test Table
[The material was borrowed from the website: MitsubishiMan]
Note: Type 1 – models with front fog lights and rear fog light; type 2 – models with only front fog lights or only rear fog light
Checking the front fog light relay or rear fog light relay
Check for a closed circuit between terminals "1" - "4" of the relay when power is not supplied.
Apply power (battery voltage) to terminals "3" (+) and "2" (–) and check for a closed circuit between terminals "1"–"4" of the relay (resistance less than 2 ohms).