Car rear suspension Mitsubishi Outlander 1

Rear suspension specifications and testing
The car uses a rear multi-link independent suspension with longitudinal levers. The shock absorber is hydraulic, cylindrical, gas-filled, double-acting. Technical...

Removal and installation suspension arms
Removal the control rod/lower control arm assembly After making a timing mark on the toe or camber adjusting bolt, disconnect the control rod or lower arm assembly....

Installing the Upper Control Arm/Steering Rod Assembly
Install the upper control arm/control rod assembly as shown in the illustration with the color marks facing the trailing arm. Examination Check the condition of the...

Removal and installation the trailing arm assembly
Support point (when lifting the vehicle/suspension) Disconnecting the lower control arm assembly and the trailing arm When removing the trailing arm, move the lift arm...

Removal and installation the shock absorber assembly
Loosening the lower suspension arm bolt Support the lower arm with a jack and unscrew the lower arm bolt. Installing the shock absorber assembly Install the stepped...

Disassembly and assembly of the shock absorber strut
Loosen the rear suspension spring nut (self-locking nut) Attention! After securing the suspension spring, install the special tool (MB991239) evenly so that its maximum...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Chassis and running gear: Rear suspension Mitsubishi Colt 4 and 5 (1991-2003)
➤ Chassis and running gear: Rear suspension Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Chassis and running gear: Rear suspension Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Chassis and running gear: Rear suspension Mitsubishi Carisma (1995-2004)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code