Doors, locks and windows of the car Mitsubishi Outlander 1

Removal and installation protective film on the side door glass frame
Removal Remove the door trim assembly. Remove the outer door opening seal. Remove the inner door window seal. Remove the door glass guide channel. Remove the door window...

Adjusting the front and rear side doors
If the gap around the perimeter between the side door and the body is uneven, stick protective tape on the body around the hinge and on the edge of the door, then use a...

Adjusting the side door glass
Check the smooth movement of the door glass along the guide groove when raising and lowering the glass to the extreme positions. If the door glass does not move up and...

Checking the travel of the outside handle of the side door
Check that the stroke "A" of the outer door handle corresponds to the nominal value. Nominal value "A" Front door: Nominal value 3.9 mm or less. Recommended value: 1.9...

Checking the current in the window lifter electric drive circuit
Remove the power window circuit fuse and connect the tester as shown in the illustration. When the window lift switch is moved to the "UP" position, the maximum current...

Removal and installation the side door assembly
Removal The parts are removed in the order shown in the figure. Before you begin removing parts, remove the door sill trim and front side trim. Installation Installation...

Removal and installation the side door lock and handle
Removal Remove the door trim assembly. Remove the waterproof film from the door. The parts are removed in the order shown in the figure. Installation Installation of...

Removal and installation the rear door assembly
Removal Remove the rear spoiler assembly. Remove the rear door trim assembly. Remove the rear window wiper motor and rear window washer hose. Remove the ceiling trim....

Removal and installation the rear door lock and handle
Removal Remove the rear door sill trim. Remove the lower rear door trim. Remove the waterproof film from the door. The parts are removed in the order shown in the...

Removal and installation the roof hatch
Removal Remove the ceiling trim. Remove the front side trim. The parts are removed in the order shown in the figure. Installation Installation of parts is carried out in...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Body and interior: Doors, locks and windows Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Body and interior: Doors, locks and windows Mitsubishi Galant 6 and 7 (1987-1998)
➤ Body and interior: Doors, locks and windows Mitsubishi L200 4 (2005-2014, diesel)
➤ Body and interior: Doors, locks and windows Mitsubishi Pajero 4 (2006-2021)
➤ Body and interior: Doors, locks and windows Mitsubishi Carisma (1995-2004)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code