Car clutch repair Mitsubishi Outlander 1

Recommended precautions
The most effective precaution taken in maintenance practice to prevent the risk of skin contact with mineral oils is the use of closed systems for the removal of used...

Checking the level of working fluid in the clutch hydraulic drive
Check the brake fluid level. If the fluid level is below the minimum level, add the required amount up to the "Max" mark. Recommended brake fluid: DOT3 or DOT4.

Checking the clutch
Check the operation of the clutch in all driving modes. Turn away the mat under the clutch pedal. Check the clutch pedal travel – the distance between the clutch pedal...

Checking the free travel of the clutch pedal
Measure the free travel of the clutch pedal (including the free travel at the pedal-pin joint). Standard value: 4–13 mm. If the clutch pedal free play does not...

Description of the clutch design
Cars with manual transmissions are equipped with a single-plate dry clutch with asbestos-free linings and a dual-mass flywheel. The clutch is controlled by a hydraulic...

Bleeding the Clutch Hydraulic Drive
Caution! Use only the specified brake fluid. Do not mix brake fluids. Brake fluid: DOT 3 or DOT 4. Remove the upper front suspension strut. Disconnect the brake pipe...

Possible clutch malfunctions, their causes and solutions
Possible clutch malfunctions, their causes and solutions

Removal and installation the clutch pedal
Before you begin removing parts, remove the lower instrument panel cover. The parts are removed in the order shown in the figure. Installation of parts is carried out in...

Removal and installation the clutch hydraulic drive
Before removing parts (drain the fluid from the clutch hydraulic drive). Removal the clutch master cylinder Disconnect the brake pipe retainer and remove the master...

Disassembly and assembly of the clutch master cylinder
The parts are removed in the order shown in the figure. Installation of parts is carried out in the reverse order of removal. When installing the parts, pay attention to...

Removal and installation the clutch
The parts are removed in the order indicated in the corresponding general drawing. Removal the clutch release fork Move the clutch release fork in the direction shown to...

Checking the clutch elements
Clutch housing Inspect the diaphragm spring petal tips for wear and petal tip height discrepancy. Replace parts if wear is evident or petal tip height discrepancy...

Disassembly and assembly of the clutch hydraulic drive slave cylinder
Note: Disassembly is performed in the order shown in the figure. Wrap the slave cylinder with a rag to prevent the piston from flying out during removal and to avoid...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Transmission: Clutch and drive shafts Mitsubishi Colt 5 (1995-2003, petrol)
➤ Transmission: Clutch Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Transmission: Clutch and drive shafts Mitsubishi Galant 5 (1983-1989, petrol)
➤ Transmission: Clutch Mitsubishi L200 4 (2005-2014, diesel)
➤ Transmission: Clutch Mitsubishi Pajero 4 (2006-2021)
➤ Transmission: Clutch Mitsubishi Carisma (1995-2004)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code