Exterior (external elements) of the car Mitsubishi Outlander 1

Features of the car body design
The car body is a load-bearing five-door car body, consisting of a frame and attachments. The body frame includes a base, sidewalls, roof and frame parts connected to...

Removal and installation the front bumper
Remove the radiator grille. Disconnect the front fog light connector. The parts are removed in the order shown in the figure. Installation of parts is carried out in the...

Disassembling and assembling the front bumper
The parts are removed in the order shown in the figure. Removal rivets Use a drill to make a hole (4.0 mm diameter) in the rivet and remove it. Installation Installation...

Removal and installation the rear bumper
Removal Remove the rear combination light. Remove the rear door sill trim. Remove the vent cover. Disconnect the rear bumper wiring harness connector. The parts are...

Removal and installation the radiator grille
The parts are removed in the order shown in the figure. Removal the retainers To remove the radiator grille, pull the radiator grille slightly towards you and use a...

Removal and installation wing linings
The parts are removed in the order shown in the figure. Removal rivets Drill a hole (6.5mm diameter for rivet "A" and 4.0mm diameter for rivet "B") into the rivet and...

Removal and installation moldings
Before you begin removing parts, remove the roof rack supports. Removal the roof drainage molding To remove the molding, pry it up using a special tool. Attention! If...

Removal and installation the threshold molding
The parts are removed in the order shown in the figure. When removing parts, pay attention to the operation of removing the threshold trim. Installation of parts is...

Removal and installation the rear spoiler
Removal Remove the upper rear door trim. Disconnect the high brake light connector. Disconnect the rear window washer hose. The parts are removed in the order shown in...

Removal and installation roof rack supports
The parts are removed in the order shown in the figure. Installation of parts is carried out in the reverse order of removal.

Adjusting the hood
Loosen the hood mounting bolts and, by moving the hood, adjust its position so that the gap is the same on all sides. Adjust the height of the hood by turning the rubber...

Adjusting the fuel filler flap
Loosen the fuel filler flap mounting screws and adjust the position of the filler flap so that the gap between the filler flap and the body is the same around the entire...

Removal and installation the hood
Removal Remove the radiator grille. Remove the splash shield (fender liner). Remove the windshield washer hose. Remove the windshield wiper panel trim. The parts are...

Removal and installation the side rear view mirror
Removal The parts are removed in the order shown in the figure. When removing parts, pay attention to the operation of removing the mirror element. Caution! When...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Body: Exterior (external elements) Mitsubishi Colt 5 (1995-2003, petrol)
➤ Body and interior: Exterior (external elements) Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Body and interior: Exterior (external elements) Mitsubishi Galant 5 (1983-1989, petrol)
➤ Body and interior: Exterior (external elements) Mitsubishi L200 4 (2005-2014, diesel)
➤ Body and interior: Exterior (external elements) Mitsubishi Pajero 4 (2006-2021)
➤ Body and interior: Exterior (external elements) Mitsubishi Space Star (1998-2005)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code