The parts are removed in the order shown in the figure.
When removing parts, pay attention to the operation of removing the threshold trim.
Installation of parts is carried out in the reverse order of removal.
Installing protective film
Attention! Make sure that the ambient temperature is within 20-38°C and the surface where the protective film is attached is clean.
If the ambient temperature is below 20°C, heat the protective film and its installation surface to 20–30°C.
When installing the protective film, make sure that no air bubbles have formed under the film.
Clean (degrease) the places where the protective film will be installed with isopropyl alcohol.
Remove the paper backing and stick the protective film as shown in the picture.