Contents: Removal ⤓ Installation ⤓
Removal
The side protective molding is secured with clamps, which can be released using a wide spatula or screwdriver. The molding can be additionally glued.
Separate the adhesive joint using a nylon cord; for convenience, heat the molding with a hair dryer to 40°C.
Installation
Treat the gluing area on the body with gasoline. Remove the protective film from the marked areas. When installing an old molding, remove the remaining glue with gasoline and apply double-sided adhesive tape 1 mm thick and 5 mm wide to the marked areas. Heat the molding and body to a temperature of 40° to 80°C and press the molding to the body.
Press your palm down in the middle to snap each clip (if any).
The material was borrowed from the website www.mitsubishiman.ru