Vehicle ignition system Mitsubishi Colt 4 and 5

General description of the ignition system
The ignition system ensures reliable ignition of the working mixture in the engine cylinders in accordance with the order of cylinder operation. The working mixture is...

Safety precautions when working with the ignition system
To avoid injury to people or failure of the electronic ignition system, the following precautions must be taken: Do not touch or remove spark plug wires while the engine...

Ignition coil
Early models In these vehicles, the ignition coil is built into the distributor. Ignition coil installation location in the distributor The resistance of the primary...

Ignition timing — check
On engines with transistor ignition, the ignition timing is usually not knocked down, but it should be checked. The ignition timing should be set after loosening the...

Ignition distributor — removal and installation
Early models Distributor elements of early years of production Removal Disconnect the ground cable from the battery. Disconnect the battery only when the ignition is...

Ignition system elements without distributor — removal and installation
4-cylinder engines with MPI injection system Elements of the ignition system of 4-cylinder engines 1 - candle; 2 - spark plug tip; 3 - ignition coil; 4 - lid; 5 -...

Camshaft and crankshaft position sensors — removal and installation
Mounting elements of camshaft and crankshaft position sensors 1 - crankshaft position sensor; 2 - idler pulley; 3 - camshaft position sensor. Removal Remove the timing...

Knock sensor — removal and installation
Knock sensor mounting elements 1 - knock sensor; 2 - support; 3 - vacuum container. Removal Remove the vacuum container and bracket. Loosen the bolts and remove the heat...

Spark plugs — checking, removal and installation
Spark plugs ignite the working mixture in the cylinder when the piston reaches the top dead center (end of the compression stroke). Controlled combustion, in which the...

Spark Plug Wires — Checking and Replacing
When adjusting, carefully inspect their insulation for burns, cracks or breaks. Check the wire caps on the spark plugs, ignition coil and distributor cap. Replace...

Ignition system fault diagnostics
Ignition system fault diagnostics

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Power unit: Ignition system Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Electrical equipment: Ignition system Mitsubishi Outlander 1 (2003-2008)
➤ Power unit: Ignition system Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Power unit: Ignition system Mitsubishi Space Star (1998-2005)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code