Electrical equipment and appliances Mitsubishi Colt 4 and 5

Basic concepts of electricity
WARNING: Understanding the basics of electrical theory makes troubleshooting electrical equipment easier. Various electrical instruments are used to diagnose electrical...

General recommendations for troubleshooting electrical equipment
Electrical faults are divided into three types: An electrical consumer that is not working is not supplied with current. The consumer himself does not work. The consumer...

General description of the car's electrical equipment
The main components of a 12-volt electrical system with a grounded negative are a 12-volt battery, a generator (driven by the crankshaft pulley), and a starter. The...

Checking the lamps
After removing the lamp, inspect it. If the filament is burnt out or the glass bulb is loose on the base, replace the lamp. Accurate lamp check: connect the lamp via...

Checking Electric Motors
Electric motors perform many functions in a car: Check or replace the electric motor fuse. The electric motors of the electric window lift and sunroof have automatic...

Checking switches
The function of switches is to close or open an electrical circuit. Some electrical consumers are switched on and off manually. There are switches that operate...

Checking the relay
In cars, relays operate in many electrical circuits: intermediate relay, functional relay, warning relay, etc. Checking the switching relay When an electrical consumer...

Checking the windshield wiper motor
The windscreen wiper motor is located in the water collection compartment under the windscreen, the rear window wiper is in the tailgate. To check, you need to remove...

Checking the turn signal switch
The vehicle's hazard warning lights and direction indicators are protected by different fuses. If the blinking rhythm on different sides is uneven, it should be assumed...

Checking the brake light
Check the fuse in the fuse box. If the fuse is faulty, check or replace the brake light bulb. If the brake light bulbs are not damaged, check the brake light switch,...

Checking the rear window defroster
If the rear window defroster does not operate properly, check the fuse in the fuse box. If the fuse is working properly, check the connector near the rear window; there...

Disconnecting and connecting connectors in Mitsubishi
When disconnecting connectors from the fuse box or from electrical consumers, pull not by the cable, but by the connector. Press the locking tab and pull the connector...

Fuses — location and replacement
To prevent damage to the electrical system due to short circuit or overload, each individual electrical circuit is equipped with a fuse. Fuse boxes are located in the...

General description of the lighting system
The lighting system includes headlights, taillights, brake lights, reversing lights, direction indicators, fog lights and rear fog lights, license plate lighting, engine...

Replacement of outdoor lighting lamps
Turn off the corresponding switch. Headlights Open the engine compartment hood. Remove the battery retaining bar next to the right headlight and lift the coolant...

Headlight adjustment
Precise adjustment of headlights is performed using special equipment. Therefore, this publication only describes where and under what conditions the correct adjustment...

Front fog lights
Adjustment Measure the center of the fog light as shown in the illustration. Set the distance from the centres of the fog lights to the screen (1) to 5 m, as shown in...

Checking the Front Fog Light Switch Circuits
Remove the front fog light switch. To remove the front fog light switch, use a screwdriver blade to pry up the switch trim, then disconnect the electrical connector and...

Checking the light switch, low beam switch and turn signals
To check, you need to use the tester in resistance measurement mode. Disconnect the electrical connectors from the switch and measure the condition (closed or open) of...

Replacing the wiper blade rubber
If the glass is not cleaned well, the wiper blades should be replaced. The blades are sold both as a set and separately. Lift the brush lever to remove the brush. From...

Windscreen washer nozzles — removal, installation and adjustment
Removal Open the engine hood. Disconnect the supply hose from the injector. Remove the nozzle from the hood upwards. Installation Place the nozzle on top and press it...

Windscreen wiper motor — removal and installation
Removal Disconnect the ground cable from the battery. Mark the position of the wiper blades on the glass. Remove the wiper arms from the windshield wiper shafts....

Windscreen washer — description and refilling
The windshield washer line consists of a reservoir, a washer pump, pipes and nozzles. When the control lever is pressed, voltage is supplied to the windshield washer...

Electric window lift — check and repair
Examination Electric window lift motors are removed in the same way as mechanical window lift motors. Electric motors cannot be repaired. If neither door glass moves,...

Diagnosing Windshield Wiper Problems
Diagnosing Windshield Wiper Problems Sign of malfunction Possible reasons Method of elimination Slippage Contamination of rubber bands Clean the rubber bands with a...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Electrical equipment: Equipment and devices Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Electrical equipment: Equipment and devices Mitsubishi Galant 6 and 7 (1987-1998)
➤ Electrical equipment: Equipment and devices Mitsubishi L200 4 (2005-2014, diesel)
➤ Electrical equipment: Equipment and devices Mitsubishi Outlander 1 (2003-2008)
➤ Electrical equipment: Equipment and devices Mitsubishi Pajero 4 (2006-2021)
➤ Electrical equipment: Equipment and devices Mitsubishi Carisma (1995-2004)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code