Checking the Front Fog Light Switch Circuits (Mitsubishi Colt 4)

Remove the front fog light switch.

To remove the front fog light switch, use a screwdriver blade to pry up the switch trim, then disconnect the electrical connector and remove the front fog light switch from the trim.

To check, you need to use the tester in resistance measurement mode.

Measure the state (closed or open) of the electrical circuits between the contacts, which must correspond to those shown in the figure. Take measurements in all switch positions.

Check the condition of the switch contacts. If the contacts are oxidized, clean them.

If the electrical circuit condition does not meet the required conditions, replace the switch.

The article was taken from the website: mitsubishiman.ru