Elements of body and interior of car Mitsubishi Colt 4 and 5

Body and interior maintenance
Body maintenance The condition of the car body has a great impact on its value. Maintenance is not complicated, but it should be done regularly. Neglecting to eliminate...

Repair of minor body damage
If there is damage to the body, remove nearby decorative trim pieces, then tap the damaged area with a hammer. Now remove the paint from the damaged area using...

Repair of minor car body scratches
If the scratch is not deep and does not penetrate the metal, body repair is not difficult. Treat the scratched area with a restorer or very thin polishing paste to...

Car body dent repair
If a dent appears in the car body, the first thing you need to do is push it out to restore the original shape of the body. There is some difficulty in giving the body...

Repair of rusted areas and holes in the body
Remove paint from the damaged area and the surrounding metal for about 2.5 cm using sandpaper, a wire brush or a drill attachment. Once the paint has been removed, you...

Body repair — putty and painting
Before reading this section, read the previous sections of this chapter. There are many types of putty, but the most convenient to use is the one that comes with a can...

Side molding — removal and installation
Removal The side protective molding is secured with clamps, which can be released using a wide spatula or screwdriver. The molding can be additionally glued. Separate...

Hood — removal and installation
Removal Open the hood and place a clean rag under the corners of the hood. If there is an engine compartment light, disconnect the electrical connector from the light...

Front wing — removal and installation
Removal Remove the front bumper, headlight, side fairing. Loosen the self-tapping bolts and remove the splash shield (1). Remove the side turn signal (2). Unscrew the...

Doors — adjustment
If the gap between the door and the body is uneven, stick protective tape on the surface of the door and the surface around the door hinge on the body. Then, using a...

Doors — removal and installation
Door elements A - front door; B - rear door; 1 - door limit switch; 2 - lid; 3 - retainer; 4 - lower loop; 5 - upper loop; 6 - door; 7 - pin; 8 - wire connector. Removal...

Rear view mirror (side) — removal and installation
Rear view mirror elements 1 - connector; 2 - mirror; 3 - body; 4 - gasket; 5 - outer cover; 6 - frame; 7 - lid; A - Manually controlled mirror; B - electrically...

Front seats — removal and installation
Removal Remove the rear floor console assembly. Using a screwdriver blade as a lever, remove the seat heating switch (1) (vehicles equipped with a seat heating system)....

Rear seat — removal and installation
Removal Remove the headrest (1) from the guides (5). After lifting the rear seat cushion, unscrew the seat hinge mounting bolts and remove the seat cushion (2). Loosen...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code