Brake system of the car Mitsubishi Colt 2 and 3

Technical characteristics of the brake system
Brake fluid type See Chapter 1 Clearance between the servo booster pushrod and the master cylinder piston Precis (1989 and earlier) 0.40-0.80 mm Precis (1990 and later)...

General description of the braking system
All vehicles covered in this manual have hydraulic brakes. The front brakes are disc brakes, and the rear brakes can be disc or drum brakes. Hydraulic system The...

Anti-lock Brake System (ABS) — General Description
The ABS system is designed to maintain vehicle control and provide optimal braking when the brake pedal is pressed sharply on any road surface. Hydraulic system The...

Brake pads for disc brakes (front and rear) — replacement
Warning! Brake pads must be replaced on both front or rear wheels at the same time. Dust from worn brake pads contains asbestos, which is hazardous to health. Do not...

Disc Brake Caliper — Removal, Overhaul and Installation
Removal 1. Pump out the brake fluid from the reservoir. 2. Raise the vehicle and remove the wheels. Sumitomo calipers 3. Remove the brake pads from the caliper. 4....

Brake disc — inspection, removal and installation
1. Raise the vehicle and remove the wheel. 5.2 Hang the support on a piece of wire 2. Remove the brake caliper, pads and caliper bracket (5.2). Inspection 3. Inspect the...

Drum brake pads — replacement
Attention! Brake pads must be replaced simultaneously on both wheels. Caution: When replacing the brake pads, it is recommended to also replace the return spring, the...

Wheel cylinder — removal, overhaul and installation
Removal 1. Raise the vehicle and remove the wheel. 2. Remove the brake pads. 3. Clean the wheel cylinder and the area around it. 6. Remove the wheel cylinder from the...

Brake Master Cylinder — Removal, Overhaul and Installation
1. The master brake cylinder is installed in the engine compartment on the servo booster. 2. Pump out as much brake fluid from the reservoir as possible. 3. Place rags...

Pressure relief valve — removal and installation
Removal 1. To diagnose the valve, you need to contact specialists. However, a car enthusiast can remove and install the valve himself. 2. The pressure limiting valve is...

Brake Hoses and Tubes — Checking and Replacing
1. Approximately every six months, brake hoses should be inspected for cracks, wear and other damage. 2. When replacing tubes and hoses, use only original spare parts....

Bleeding the brake system
Conventional braking system (without ABS) 1. If air entered the system through the reservoir or when removing the master brake cylinder, it is necessary to bleed the...

Brake booster — checking, removal and installation
Examination 1. Depress the brake pedal several times with the engine off and check that the brake pedal travel does not change. 2. Press the brake pedal and start the...

Handbrake — adjustment
1. Check the handbrake lever stroke. It should not rise more than 5-7 clicks. Otherwise, adjust the handbrake. 2. Remove the center console. 13.3a On some models the...

Handbrake cables — replacement
1. Remove the center console. 2. Unscrew the adjusting nut of the cable to be removed. 3. Raise the rear of the vehicle and remove the rear wheel. 4. Remove the brake...

Brake light switch — removal, installation and adjustment
1. Remove the lower trim panel under the steering column. 2. The brake light switch is located on the left above the brake pedal. Disconnect the switch connector. 3....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Chassis and running gear: Brake system Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Chassis and running gear: Brake system Mitsubishi Galant 5 (1983-1989, petrol)
➤ Chassis and running gear: Brake system Mitsubishi L200 4 (2005-2014, diesel)
➤ Chassis and running gear: Brake system Mitsubishi Outlander 1 (2003-2008)
➤ Chassis and running gear: Brake system Mitsubishi Pajero 4 (2006-2021)
➤ Chassis and running gear: Brake system Mitsubishi Space Star (1998-2005)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code