Car clutch and drive shafts Mitsubishi Colt 2 and 3

This chapter describes the procedures for repairing the axle shafts and the clutch mechanism.

Clutch and drive shaft specifications
Clutch Free pedal travel See Chapter 1 Minimum permissible thickness of friction material 0.3 mm above rivet heads Half shafts Length of inner CV joint (approx.) Cordia...

Clutch — description and testing
2.1 Clutch elements - models with mechanical clutch release drive 1. Bolts securing the pressure plate to the flywheel; 2. Pressure disc; 3. Slave disk; 4. Release...

Release Bearing, Clutch Release Fork and Fork Axle — Removal and Installation
1. Remove the gearbox. 2.1 Clutch elements - models with mechanical clutch release drive 1. Bolts securing the pressure plate to the flywheel; 2. Pressure disc; 3. Slave...

Clutch release cable — removal, installation and adjustment
Removal 1. Disconnect the negative battery cable. 2. Unscrew the adjusting nut. 5.3a The cable is attached to the fork lever using a pin and a cotter pin - after...

Clutch release master cylinder — removal, overhaul and installation
Removal 1. Disconnect the negative battery cable. 6.2 Clutch release master cylinder fastening elements 1. Cheka; 2. Washer; 3. Pin 2. Disconnect the cylinder push rod...

Clutch release drive slave cylinder — removal, overhaul and installation
1. Disconnect the tube from the cylinder and close its end. 2. Remove the fork pin. 3. Loosen the mounting bolts and remove the cylinder. 4. Press the piston out of the...

Clutch release hydraulic system — bleeding
1. The hydraulic system must be bled to remove air from it. 2. Fill the reservoir with fresh D0T3 brake fluid. 3. Remove the cap from the release valve and connect a...

Half shafts — general description and inspection
1. The drive is transmitted from the gearbox to the wheels via the axle shafts. Constant velocity joints (CV joints) are installed at the ends of the axle shafts. The...

Half shafts — removal and installation
Removal 10.1 When the car is on the ground, unscrew the nut securing the hub to the axle shaft 1. Unscrew the nut securing the hub to the axle shaft. Raise the vehicle...

Replacement of covers and overhaul of CV joints
1. Remove the axle shaft from the vehicle. 2. Place the axle shaft in a vice. 11.3 Bend back the fastening tabs with a screwdriver and remove the clamp 3. Remove the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Transmission: Clutch Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Transmission: Clutch Mitsubishi Galant 6 and 7 (1987-1998)
➤ Transmission: Clutch Mitsubishi L200 4 (2005-2014, diesel)
➤ Transmission: Clutch Mitsubishi Outlander 1 (2003-2008)
➤ Transmission: Clutch Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Transmission: Clutch Mitsubishi Carisma (1995-2004)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code