Removal
1. Disconnect the negative battery cable.
6.2 Clutch release master cylinder fastening elements
1. Cheka; 2. Washer; 3. Pin
2. Disconnect the cylinder push rod from the clutch pedal (6.2).
3. Disconnect the hydraulic pipe from the cylinder.
4. Unscrew the two nuts securing the cylinder and remove it.
Bulkhead
5. Drain the hydraulic fluid and remove the can from the cylinder.
[The original article is on the website: www.mitsubishiman.ru]
6.6 Clutch release master cylinder components
1. Split retaining ring; 2. Pusher; 3. Cover; 4. Piston; 5. Lid; 6. Clamp; 7. Tank; 8. Master cylinder; 9. Disconnect the spring from the piston; 10. Remove the spring seat, seal and washer from the pushrod; 11. Remove the seal from the piston; 12. Inspect the inside surface of the cylinder for scratches or signs of wear and replace it if necessary; 13. Before installation, wash all components in alcohol, clean brake fluid or brake cleaning fluid. Do not use gasoline-based solvents; 14. Install the seal on the piston. The edges of the seal should be facing away from the piston pusher; 15. Install the spring on the piston; 16. Lubricate the inner surface of the cylinder and seals with clean brake fluid (DOT3); 17. Carefully install the piston into the cylinder; 18. Install the pushrod and washer into the cylinder, compress the spring and install a new split retaining ring; 19. Lubricate the dust cap and install it on the cylinder
6. Move the boot on the pusher (6.6) and remove the split retaining ring.
7. Remove the pusher.
8. Knock the piston out of the cylinder.
Installation
20. Install the master cylinder to the rear wall of the engine compartment and lightly tighten the mounting nuts.
21. Connect the hydraulic tube to the cylinder.
22. Tighten the cylinder mounting nuts to the specified torque, then tighten the tube connection.
23. In the passenger compartment, connect the push rod to the clutch pedal.
24. Fill the cylinder reservoir with hydraulic fluid and bleed the hydraulic system.