Contents: Removal ⤓ Installation ⤓
Caution! First drain the fluid from the clutch hydraulic drive. It is prohibited to disassemble the piston of the clutch hydraulic drive master cylinder.
Removal
To remove the clutch master cylinder, perform the following operations in sequence.
Fig. 10.9. Master cylinder of the hydraulic clutch drive of cars with gasoline engines: a – place of lubrication with brake fluid; b – place of application of lubricant that does not destroy rubber; 1 – tank lid; 2 – clutch hydraulic reservoir; 3 – container mounting clamp; 4 – clutch hydraulic drive master cylinder housing; 5 – piston assembly (lubricate with brake fluid); 6 – piston retaining ring; 7 – pusher assembly; 8 – lock nut (13 Nm)
1. Remove the piston retaining ring 6 (Fig. 10.9).
The article was obtained from this portal [mitsubishiman]
2. Remove the pusher 7 as an assembly.
3. Remove piston 5 as an assembly.
4. Remove the tank lid.
5. Remove the container mounting clamp.
6. Remove the clutch fluid reservoir.
Installation
Installation is carried out in the reverse order of removal.