Multipoint fuel injection MPI system Mitsubishi Space Star

Diagnostics in the «DIAGNOSIS 2» mode
1. Using the MUT-II device, switch the electronic control unit to the diagnostic mode "DIAGNOSIS 2". 2. Conduct a road test. 3. Read diagnostic codes and correct any...

Testing using the «DATA LIST» and «ACTUATOR TEST» modes of MUT-II
1. Perform a check using the MUT-II DATA LIST and ACTUATOR TEST modes. If a fault is detected, check the vehicle's electrical wiring, relevant components and parts. 2....

FREEZE FRAME data on a 2000 model year vehicle
When the engine control module (vehicles with manual transmission) or the engine and automatic transmission control module (vehicles with automatic transmission) detects...

Checking the engine air temperature sensor
1. Disconnect the connector from the intake manifold pressure sensor (Fig. 7.4). Fig. 7.4. Location of the pressure sensor in the intake manifold 2. Measure the...

Checking oxygen concentration sensors
The heated oxygen sensor detects the oxygen concentration in the exhaust gases and converts it into a voltage, which it transmits to the engine control unit (ECU). Front...

Fuel injectors
Removal Disconnect the cable from the negative battery terminal. Reduce the pressure in the fuel system. Remove the bolts, disconnect the accelerator cable end from the...

Throttle assembly
Removal Drain the coolant from the cooling system. Remove the air intake hose. Remove the bolts, disconnect the accelerator cable end from the throttle assembly and...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Power unit: Fuel injection MPI Mitsubishi Colt 4 and 5 (1991-2003)
➤ Power unit: MPI fuel injection system Mitsubishi Lancer 9 (2000-2007, petrol)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code