Car headlights and lighting Mitsubishi Carisma

Headlight adjustment
The headlight beam adjustment should be carried out using appropriate lighting devices in compliance with the requirements of the manufacturer's instructions for these...

Measuring the brightness of headlights
1. Using a photometer and following the manufacturer's instructions, measure the brightness of the headlights. The limit value is not less than 30,000 cd. Caution: When...

Replacing lamps
General information When replacing lamps, follow these steps: 1. Disconnect the cable from the negative terminal of the battery. 2. Before replacing the lamp, check the...

Headlights and direction indicators
Fig. 19.19. Headlight of cars produced since 1995: 1 – radiator trim; 2 – headlight; 3 – screw (0.75 Nm); 4 – front turn signal; 5 – nut (4.9 Nm) 1. Remove the expansion...

Checking switches, switches and relays
To check, you need to use the tester in resistance measurement mode. Fig. 19.22. Checking the light switch, low beam switch and turn signal switch: 1 – closed terminals...

Side direction indicators
Fig. 19.25. Using a flat special tool to release the side turn signal retainer: 1 – wing panel; 2 – flat tool; 3 – retainer 1. Using a flat special tool, release the...

Front fog lights
Adjusting the fog lights Fig. 19.27. Location of the fog lamp center 1. Measure the center of the fog lights as shown in Fig. 19.27. Fig. 19.28. Positioning the vehicle...

Rear combination light
Removal To remove, follow these steps. Fig. 19.37. Rear combination light for hatchback vehicles: 1 – lantern cover; 2 – rear combination light assembly; 3 – rear light...

Checking the rear fog light switch circuits
1. Remove the rear fog light switch. Fig. 19.39. Removing the rear fog light switch: A – vehicles not equipped with fog lights; B – vehicles equipped with fog lights; 1...

High Brake Light — Removal and Installation
Removal To remove, follow these steps. Fig. 19.42. Location of the groove of the upper brake light retainer 1. Position the locking groove as shown in Fig. 19.42, then...

Instrument cluster backlight rheostat — removal and installation
Removal To remove, follow these steps. 1. Remove the rheostat. Fig. 19.44. Removing the rheostat: 1 – Switch cover; 2 – rheostat 2. To remove the rheostat, use a...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Electrical equipment: Headlights and lighting Mitsubishi Outlander 1 (2003-2008)
➤ Electrical equipment: Headlights and lighting Mitsubishi Pajero 1 and 2 (1982-1999)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code