F9Q diesel engines Mitsubishi Carisma

Specifications and data
Specifications and data

Checking and adjusting valve clearances
Examination 1. Checking and adjusting valve clearances must be carried out on a cold engine. 2. Remove the cylinder head cover. 3. Identify a cylinder with equally open...

Checking the engine crankshaft speed at idle speed
1. Prepare the vehicle for testing (warm up the engine to normal operating temperature). 2. Turn the ignition key to the "LOCK" ("OFF") position and connect the MUT II...

Compression check
1. Before starting the test, check the condition of the engine oil, starter and battery. Prepare the car for testing (warm up the engine to normal operating temperature...

Adjusting the timing belt tension of the gas distribution mechanism
1. Connect the MUT II device to the diagnostic connector. 2. Remove the timing belt cover. 3. Turn the crankshaft clockwise and set the piston of the 1st cylinder to TDC...

Crankshaft pulley — removal and installation
Removal 1. Remove the protective cover. Fig. 5.4. Crankshaft pulley: 1 – bolt, 10 Nm; 2 – Power steering pressure hose clamp; 3 – bolt, 10 Nm; 4 – Air conditioner...

Camshaft and camshaft oil seal
Removal 1. Disconnect the cable from the negative terminal of the battery. 2. Drain the coolant from the engine cooling system. 3. Remove the air filter. 4. Remove the...

Engine oil pan — removal and installation
Fig. 5.9. Engine oil pan: 1 – engine oil pan; 2 – drain plug, 25 Nm; 3 – sealing ring; 4 – bolt, 13 Nm Removal 1. Disconnect the cable from the negative terminal of the...

Crankshaft seals — removal and installation
Front crankshaft oil seal Removal 1. Remove the timing belt. Fig. 5.10. Crankshaft oil seals: 1 – crankshaft pulley; 2 – key; 3 – front crankshaft oil seal; 4 – rear...

Cylinder Head Gasket — Removal and Installation
Removal 1. Drain the coolant from the engine cooling system. 2. Drain the engine oil from the engine. 3. Remove the inlet hose and air filter. 4. Remove the exhaust pipe...

Gas distribution mechanism drive belt
Removal 1. Disconnect the cable from the negative terminal of the battery. 2. Remove the engine mount bracket. Fig. 5.15. Timing belt of the gas distribution mechanism:...

Removal and installation the engine assembly
Removal 1. Disconnect the cable from the negative terminal of the battery. 2. Remove the hood. 3. Drain the coolant from the engine cooling system. 4. Remove the air...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code