Car steering Mitsubishi Space Star

Steering — technical data
General information Steering gear type - composite transmission type - rack and pinion Oil pump type - bladed productivity, ml/rev — 5.9 maximum discharge pressure, MPa...

Checking the steering wheel free play
1. Start the engine with the steering wheel in the straight-ahead position. 2. Measure the free play around the steering wheel circumference. Free play of the steering...

Checking the front wheel steering angle
1. Turn the front wheels of the car to the maximum angle and measure the turning angle of each wheel. Rotation angle: inner wheel: 39°00' + 1°30' outer wheel: 32°00'...

Checking the torque of the ball joint pin of the tie rod end
1. Using a special tool, disconnect the steering rod end from the steering knuckle (Fig. 16.3). Fig. 16.3. Using a special tool to disconnect the tie rod end from the...

Checking the steering wheel turning force
1. With the vehicle on a firm, level surface, set the front wheels to straight ahead. 2. Increase the engine crankshaft speed to 1000±100 min⁻¹ Warning: After checking,...

Checking the return of the steering wheel to its original position
To perform this check, perform a road test and do the following. 1. While driving, make several smooth and then sharp turns of the steering wheel to the right and left...

Checking the fluid level
1. Place the car on a flat horizontal surface. Start the engine and warm up the power steering fluid to a temperature of 50-60°C by turning the steering wheel from lock...

Replacing the fluid in the hydraulic power steering system
1. Raise the front of the vehicle and support it on jack stands. 2. Disconnect the return hose from the tank (Fig. 16.8). Fig. 16.8. Location of hoses when replacing...

Bleeding the hydraulic power steering system
1. Raise the front wheels. 2. Disconnect the high-voltage wire from the ignition coil (1.3L engine) or the connector from the ignition coil (1.8L engine). On a vehicle...

Checking the pressure generated by the power steering pump
1. Disconnect the pressure hose from the power steering pump, connect a special measuring tool between the disconnected pressure hose and the pump as shown in Figure...

Checking the hydraulic power steering fluid pressure sensor
1. Disconnect the pressure hose from the power steering pump. Connect a special measuring tool between the disconnected pressure hose and the pump as shown in Figure...

Steering wheel and steering shaft
Removal 1. Disconnect the cable from the negative terminal of the battery. 2. Remove the lower instrument panel trim panel. 3. On a vehicle without SRS, remove the horn...

Steering gear
Removal 1. Drain the fluid from the power steering hydraulic drive. 2. Disconnect the cable from the negative terminal of the battery. 3. Remove the cross beam. 4 Remove...

Power steering pump for a car with a gasoline engine
Fig. 16.24. Power steering pump of a car with a gasoline engine: 1 - pump drive belt; 2 - pressure sensor connector; 3 - suction filter; 4 - pressure hose; 5 - sealing...

Power steering pump for diesel vehicle
Removal 1. Drain the power steering fluid. 2. Loosen the tension and remove the pump drive belt (Fig. 16.25). Fig. 16.25. Power steering pump of a vehicle with a diesel...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Chassis and running gear: Steering Mitsubishi Colt 4 and 5 (1991-2003)
➤ Chassis and running gear: Steering Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Chassis and running gear: Steering Mitsubishi Galant 5 (1983-1989, petrol)
➤ Chassis and running gear: Steering Mitsubishi L200 4 (2005-2014, diesel)
➤ Chassis and running gear: Steering Mitsubishi Outlander 1 (2003-2008)
➤ Chassis and running gear: Steering Mitsubishi Pajero 4 (2006-2021)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code