Car engine ignition system Mitsubishi Space Star

Ignition system — technical data
Single overhead camshaft engine ignition distributor Type - contactless, with built-in ignition coil The ignition timing mechanism is electronic The firing order of the...

Checking the ignition coil (MPI)
When measuring the resistance of the primary winding of the ignition coil, measure the resistance between contacts 1 and 2 of the ignition distributor connector (Fig....

Power Transistor Test (MPI)
1. Use an analog meter to test the power transistor. 2. Connect the negative probe of the device to contact 2 of the ignition distributor connector, and the positive...

Ignition coil with built-in power transistor
Checking the primary winding of the ignition coil and power transistor (GDI and 4G13-MPI) 1. Use an analog meter to check. 2. Connect the negative probe of the device to...

High Voltage Wire Inspection (MPI)
When disconnecting the high-voltage wire tip from the spark plug, do not pull on the wire, but only on the tip, while turning the tip half a turn in one direction and...

Checking and cleaning spark plugs
DOHC (GDI) Engine Warnings 1. Do not adjust the spark plug gap on iridium-tipped spark plugs. 2. Cleaning the spark plugs may damage the iridium electrodes. Therefore,...

Checking the misfire detection sensor
Note: Please use an analog meter to check Disconnect the connector from the misfire detection sensor and check the resistance between contacts 3 and 4 of the connector...

DOHC Engine Ignition Coils (GDI and 4G93-GDI)
Removal Disconnect the cable from the negative battery terminal. Remove the bolts and remove the engine cover. Disconnect the connectors from the ignition coils (Fig....

SOHC Engine Ignition Coils (4G13-MPI)
Removal Disconnect the cable from the negative battery terminal. Disconnect the connectors from the ignition coils (Fig. 9.10) Fig. 9.10. SOHC engine ignition coils...

Camshaft Position Sensor
Removal Disconnect the cable from the negative battery terminal. Disconnect the connector from the camshaft position sensor (Fig. 9.11). Fig. 9.11. Camshaft position...

Crankshaft angle sensor
Fig. 9.12. Camshaft angle sensor (1) of the SOHC engine (4G13-MPI) Removal Disconnect the cable from the negative battery terminal. On DOHC (GDI) engine, remove the...

SOHC Engine Ignition Distributor (MPI)
Removal Disconnect the cable from the negative terminal of the battery. Remove the air filter. Disconnect the high-voltage wires from the ignition distributor (Fig....

Knock sensor
Detonation combustion of fuel occurs when ignition is too early and the engine is running on fuel with a low octane number. Detonation occurs when the flame propagation...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Power unit: Ignition system Mitsubishi Colt 4 and 5 (1991-2003)
➤ Power unit: Ignition system Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Electrical equipment: Ignition system Mitsubishi Outlander 1 (2003-2008)
➤ Power unit: Ignition system Mitsubishi Pajero 1 and 2 (1982-1999)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code