Contents: Removal ⤓ Installation ⤓
Removal
- Disconnect the cable from the negative battery terminal.
- Disconnect the connectors from the ignition coils (Fig. 9.10)
Fig. 9.10. SOHC engine ignition coils (4G13-MPI): 1 - ignition coil connector; 2 - high voltage wires; 3 - ignition coil; 4 - spark plug; 5 - misfire detection sensor connector; 6- misfire detection sensor
- Disconnect the high-voltage wires from the coils and spark plugs.
- Remove the bolts and ignition coils.
- Clean the spark plugs with compressed air to prevent dirt from getting into the engine cylinders after unscrewing the spark plugs. Use a spark plug wrench to unscrew the spark plug. To avoid damaging the spark plug, install the spark plug wrench strictly along the spark plug axis.
Installation
- Installation is carried out in the reverse order of removal.
- Screw in the spark plugs and tighten them to a torque of 25 Nm.
(The original was published on the website: mitsubishiman.ru)