Removal and installation ignition coils (Mitsubishi Outlander 1)

Removal

Remove the center cover.

Disconnect the ignition coil connector.

Disconnect the high voltage wire.

Remove the ignition coil.

Remove the spark plugs.

Installation

Installation of components is carried out in the reverse order of removal.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Arseny Pavlov

Share with friends:

◀ Previous

Outlander 1: Ignition system

Next ▶

Checking the ignition coil relay
Examples of high voltage oscillograms of a faulty ignition system
Taking high voltage waveforms using an oscilloscope
Maintenance operations performed directly on the vehicle
General information about the ignition system

Removal and installation the camshaft position sensor
Removal and installation the knock sensor
Removal and installation the ignition switch
Checking the speedometer
Checking the tachometer

Similar materials for other Mitsubishi models

➤ Checking the ignition coils of the 4G1 engine Mitsubishi Colt 5 (1995-2003, petrol)
➤ Spark plugs and ignition coils Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Ignition switch Mitsubishi Galant 6 and 7 (1987-1998)
➤ Ignition switch Mitsubishi L200 4 (2005-2014, diesel)
➤ Ignition switch — general description Mitsubishi Pajero 1 and 2 (1982-1999)
➤ DOHC Engine Ignition Coils (GDI and 4G93-GDI) Mitsubishi Space Star (1998-2005)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet