Driving and car maintenance Mitsubishi Outlander 1

Recommendations for running in a car
During the break-in period of a new vehicle (during the first 1000 km of mileage), to ensure its long service life, as well as subsequent fuel efficiency and high...

Fuel selection
Recommended fuel Unleaded petrol with octane rating 95 RON (no DIN 51607) or higher ("Super") Refueling Warning! Fuel is highly flammable and explosive. Therefore, be...

Towing a trailer
To tow a trailer, the vehicle must be equipped with a towing hitch that meets all relevant requirements of the regulations in force in your country. The towing hitch...

Ignition switch
1. The engine is off and the steering wheel is locked. The ignition key can only be inserted or removed in this position. 2. The engine is off, but you can turn on the...

Locking and unlocking the steering wheel
Blocking Remove the key from the ignition switch when it is in the "LOCK" position and turn the steering wheel until it locks. Unlock Turn the ignition key to the ACC...

Starting the engine
Do not keep the starter engaged for more than 10 seconds, as this may cause a severe discharge of the battery. If the engine does not start, return the ignition key to...

Manual transmission
The gear shift pattern is shown on the gear shift knob. Always fully depress the clutch pedal before moving the lever to another position. Warning! Do not engage reverse...

Four-speed automatic transmission INVECS-II Sport Mode
The automatic transmission is designed to provide an optimal gear shift mode and equipped with an adaptive gear selection algorithm, the automatic transmission selects...

Automatic transmission control lamps
A – Selector lever position indicator lamps. The indicator lamps on the instrument panel are designed to indicate the position of the automatic transmission selector,...

Automatic transmission selector lever positions (main slot)
"P" - Parking In this position, the gearbox is locked to prevent the vehicle from moving when parked. In this position, the vehicle engine can be started. "R" - Reverse...

Features of the automatic transmission
When starting off (with the engine running), fully depress the brake pedal before engaging the gear to prevent the vehicle from rolling slowly. The vehicle will start...

Parking brake
When parking your car in a parking lot, first of all, bring it to a complete stop and fully lift the parking brake lever. Then engage first gear if there is an uphill...

Steering wheel height adjustment
1 – locking position. 2 – position of movement. To adjust the height of the steering wheel, lower the steering wheel height adjustment lever, and while holding the...

Tools and jack
Note: The tools and jack are located under the luggage compartment floor. Removal the jack Pull strap A to remove the right side of the luggage compartment floor. Remove...

Spare wheel
Check the air pressure in the spare tire weekly to ensure that it is suitable for use in the event of an accident. By maintaining the maximum pressure in the spare tire...

Wheel replacement
If you need to replace a punctured tire, do so only after taking all necessary safety measures. Park the car in a place where it does not create a danger or hindrance to...

Wheel caps — removal and installation
Removal the cap Wrap the end of the tire iron in a cloth, insert it deep into the groove in the wheel hub cap, and use the tire iron as a lever to separate the cap from...

Towing a car
If towing is necessary, we recommend that it be performed by a MITSUBISHI dealer or a professional commercial towing company. In the following cases, the vehicle can...

Engine overheating
A – cooling system fan. B – radiator cap. C – expansion tank. If the coolant temperature gauge needle is in the overheating zone for a long time, this indicates that the...

Starting the engine from an external source
If the engine does not start due to a completely or partially discharged battery, then the battery of another car can be used to start the engine, connected via jumper...

Fuses and fuses
Fuse box To prevent damage to the electrical system due to short circuits or overloads, each individual electrical circuit is equipped with a fuse. Fuse boxes are...

Replacing bulbs in headlights and taillights
Before replacing the bulb, make sure it is turned off. Do not touch the bulb of the new bulb with bare hands. The fat from the skin remaining on the glass will evaporate...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ General information: Driving and operation Mitsubishi Galant 6 and 7 (1987-1998)
➤ General information: Driving and operation Mitsubishi Pajero 1 and 2 (1982-1999)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code