 |  |
1. The engine is off and the steering wheel is locked. The ignition key can only be inserted or removed in this position.
2. The engine is off, but you can turn on the radio, cigarette lighter, etc.
3. The engine is running and all electrical systems can be switched on.
4. The starter works. After the engine starts, release the key and it will automatically return to the "ON" position.
Note. To remove the key from the ignition lock, turn it to the "ACC" position, then press the key until it turns to the "LOCK" position, and then remove it.
For vehicles equipped with ignition switch illumination
The ignition switch illumination will turn on after you open the driver's door and will remain on for approximately 30 seconds after you close the door.
[The article was obtained from this portal: mitsubishiman]
For vehicles with remote control door locks
When you exit the vehicle and remove the ignition key, the ignition switch light will remain on for approximately 30 seconds. However, if the ignition key is turned to the "ON" position, the ignition switch light will go out.
On vehicles with external lighting, during the daytime, when the ignition key is in the "ON" position, the low beam headlights, etc. are turned on.
For vehicles equipped with an electronic immobilizer, to start the engine it is necessary that the identification code sent by the transponder (responder) built into the ignition key matches the identification code registered in the electronic immobilizer unit.
Warning: Do not remove the key from the ignition while driving, as this will lock the steering wheel and make the vehicle uncontrollable.
When the engine stops while the vehicle is moving, the brake booster stops working and the efficiency of the braking system decreases. The power steering will also not work, so more physical effort will be required to operate the steering wheel.
Do not leave the key in the "ON" position for long periods of time when the engine is not running, as this will drain the battery.
Do not turn the key to the "START" position while the engine is running. This may damage the starter.