Drive shafts and cardan car Mitsubishi Outlander 1

Checking the oil level in the front and rear axle differentials
Unscrew the oil filler plug. Check the oil level. If the oil level is just below the bottom edge of the filler hole, this is normal. For type 1 only Remove the oil...

Checking the drive shaft boots for damage
Check the drive shaft boots for damage.

Changing the oil in the differential of the front and rear axles
Remove the drain plug to drain the oil. Install the oil filler plug and tighten it to the recommended torque. Tightening torque: 64±4 Nm. Remove the oil filler plug and...
There is 1 comment

Removal and installation the propeller shaft (4WD)
Removal Mark the relative positions of the driveshaft flange and the differential pinion flange. Remove the driveshaft. Caution! Remove the cardan shaft in a straight...

Checking the cardan shaft
Check the sliding fork and center support fork for wear, damage or cracks. Check the cardan shaft pipe for deflection (beating), deformation and twisting. Check the...

Disassembly and assembly of the cardan shaft
Removal the retaining ring Before removing the retaining ring, mark the position of the universal joint forks. Removal the universal joint cross bearing Using a special...

Removal and installation the wheel drive shaft assembly
Caution! When removing and installing the drive shaft, be careful not to hit the toothed ring of the wheel speed sensor, which is installed on the outer ring of the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Transmission: Drive shafts Mitsubishi Colt 4 and 5 (1991-2003)
➤ Transmission: Drive shafts and gearbox Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Transmission: Drive shafts and transfer case Mitsubishi Galant 6 and 7 (1987-1998)
➤ Transmission: Drive shafts and axles Mitsubishi Pajero 1 and 2 (1982-1999)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code