Drive shafts and transfer case Mitsubishi Galant 6 and 7

General information about the transfer case
Of the models considered in this Manual, only all-wheel drive (AWD) Galant models produced before 1993 are equipped with a transfer case. The authors of this Manual do...

Replacing the rear transfer case oil seal
Transfer case rear oil seal installation details 1 - Air release valve; 2 - Gearbox suspension support bracket (only models with locking differential); 3 - Dust cover; 4...

Removal and installation the transfer case lever
Removal 1. Disconnect the negative cable from the battery. Warning! If the car stereo system is equipped with a security code, make sure you have the correct combination...

Removal and installation drive shafts
Removal 1. Without jacking up the vehicle, remove the cotter pins and loosen the hub nuts of the front wheels. 2. Jack up the car and place it on supports. 3. On models...

Drive shaft joints — general information and maintenance
General information Several different types of joints can be used to complete the drive shafts of the vehicles discussed in this Manual. The specific choice is...

Checking the condition of the transmission line
1. The propeller shaft is used only on all-wheel drive (AWD) models (among the series under consideration, these are Galant AWD models produced up to 1993) and serves to...

Removal and installation the propeller shaft
Design of the cardan shaft of all-wheel drive models 1 - Self-locking nut; 2 - Rubber cushion; 3 - Spacer sleeve; 4 - Cardan shaft; N - Replace Removal 1. Disconnect the...

Replacing the cardan joint
Removal 1. Mark the seating position of the hinge in the body of your clamp. Using special pliers, remove the retaining rings. 2. Using a large clamp, press the bearing...

Balancing the cardan shaft
Balancing the cardan shaft requires the use of special equipment and should be entrusted to car service specialists.

Removal and installation the propeller shaft central bearing assembly
Removal 1. Mark the position of the Lobro universal joint relative to the connecting flange. 2. Unscrew the mounting bolts and separate the hinge from the flange. 3....

Removal and installation rear axle shafts (AWD Galant models through 1993)
Removal 1. Disconnect the negative cable from the battery. If your car stereo system is equipped with a security code, make sure you have the correct combination to...

Removal and installation the rear axle hub journal, wheel bearing and seal
Removal 1. Disconnect the negative cable from the battery. If your car stereo system is equipped with a security code, make sure you have the correct combination to...

Replacing the rear differential pinion seal
Removal 1. Jack up the car and place it on supports. 2. After marking the mounting position of the components, disconnect the propeller shaft from the differential...

Removal and installation the rear differential housing (AWD Galant models through 1993)
Removal 1. Jack up the car and place it on supports. 2. Drain the transmission fluid from the differential and remove the center section of the exhaust system. 3. Mark...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Transmission: Drive shafts Mitsubishi Colt 4 and 5 (1991-2003)
➤ Transmission: Drive shafts and gearbox Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Transmission: Drive shafts and cardan Mitsubishi Outlander 1 (2003-2008)
➤ Transmission: Drive shafts Mitsubishi Pajero 4 (2006-2021)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code