Vehicle cooling and heating system Mitsubishi Galant 6 and 7

Engine cooling and heating systems
Engine cooling system All models of the vehicles considered in this Manual are equipped with a positive pressure engine cooling system with thermostatic control of the...

Cooling and Heating System Specifications
Coolant volume See Chapter Settings and ongoing maintenance Calculated pressure of the radiator cap, kgf/cm² 0.9÷1.1 (on some models it may be higher - see data on the...

Antifreeze — General Information
Warning! Do not allow antifreeze to come into contact with exposed areas of the body or painted surfaces of the vehicle. If it accidentally splashes, immediately wash it...

Checking the proper functioning and thermostat
Warning! Do not open the radiator cap or remove the thermostat until the engine has cooled down completely! See also the warning at the beginning of the Section...

Checking the condition of the cooling system fan
Warning! Avoid touching the impeller blades with your hands, tools, or clothing. To avoid injury or equipment damage, do not start the engine if the fan is faulty. Do...

Removal and installation the cooling system radiator
Warning! Do not proceed with the procedures until the engine has cooled down completely. See also warnings at the beginning of the Section Antifreeze - general...

Checking the condition of the water pump
1. A water pump failure can have the most serious consequences, including complete engine seizure due to overheating. A defective pump must be replaced. 2. Warm up the...

Removal and installation the water pump
Warning! Proceed with the procedure only after the engine has completely cooled down! See also warnings at the beginning of the Section Antifreeze - general information...

Checking and replacing the coolant temperature sensor unit
Warning! Proceed with the procedure only after the engine has completely cooled down! See also warnings at the beginning of the Section Antifreeze - general information...

Replacing the electric motor of the heater fan drive
Heater fan installation details for Mirage models 1990÷1992. 1 - Glove box; 2 - Loudspeaker grille; 3 - Front door sill trim (right-hand drive models); 4 - Knee support...

Removal and installation the heater heat exchanger
Installation details of the heater heat exchanger on Diamante models produced in 1992÷1996. 1 - Heating hose connection pipes; 2 - Right section of the lower trim of the...

Checking and servicing heating and air conditioning systems
Air conditioning system Warning! The air conditioning system is under constant high pressure. Never disconnect refrigeration lines or remove any system components...

Removal and installation the heater and air conditioner control panel, adjusting the drive cables
Warning! The vehicles covered in this manual are equipped with the Supplemental Restraint System (SRS), better known as the airbag. Before performing any work near the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Power unit: Cooling system Mitsubishi Colt 4 and 5 (1991-2003)
➤ Power unit: Cooling system Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Power unit: Cooling and lubrication system Mitsubishi Outlander 1 (2003-2008)
➤ Power unit: Cooling system Mitsubishi Pajero 4 (2006-2021)
➤ Power unit: Cooling system Mitsubishi Carisma (1995-2004)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code