Removal and installation the water pump (Mitsubishi Galant 6)

Warning! Proceed with the procedure only after the engine has completely cooled down! See also warnings at the beginning of the Section Antifreeze - general information.

See Section Removal and installation the water pump.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Dmitry Vasiliev

Share with friends:

◀ Previous

Galant 6 and 7: Cooling and heating

Next ▶

Checking the condition of the water pump
Removal and installation the cooling system radiator
Checking the condition of the cooling system fan
Checking the proper functioning and thermostat
Antifreeze — General Information

Checking and replacing the coolant temperature sensor unit
Replacing the electric motor of the heater fan drive
Removal and installation the heater heat exchanger
Checking and servicing heating and air conditioning systems
Removal and installation the heater and air conditioner control panel, adjusting the drive cables

Similar materials for other Mitsubishi models

➤ Water pump — check Mitsubishi Colt 2 and 3 (1983-1993)
➤ Removal Water from a Diesel Fuel Filter / Replacing a Fuel… Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Checking the poly V-belt of the alternator and steering… Mitsubishi L200 4 (2005-2014, diesel)
➤ Removal and installation the coolant pump Mitsubishi Outlander 1 (2003-2008)
➤ Water Pump — Removal, Checking and Installation Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Water pump — removal and installation Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet