Removal and installation the cooling system radiator (Mitsubishi Galant 6)

Warning! Do not proceed with the procedures until the engine has cooled down completely. See also warnings at the beginning of the Section Antifreeze - general information.

See Section Removal and installation the cooling system radiator (all models).

[The article is based on data from the website MitsubishiMan.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Dmitry Vasiliev

Share with friends:

◀ Previous

Galant 6 and 7: Cooling and heating

Next ▶

Checking the condition of the cooling system fan
Checking the proper functioning and thermostat
Antifreeze — General Information
Cooling and Heating System Specifications
Engine cooling and heating systems

Checking the condition of the water pump
Removal and installation the water pump
Checking and replacing the coolant temperature sensor unit
Replacing the electric motor of the heater fan drive
Removal and installation the heater heat exchanger

Similar materials for other Mitsubishi models

➤ Cooling system radiator — design description Mitsubishi Colt 5 (1995-2003, petrol)
➤ Radiator and electric fan of the cooling system Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Electronic immobilizer (anti-theft system that blocks… Mitsubishi L200 4 (2005-2014, diesel)
➤ Removal and installation the cooling system radiator Mitsubishi Outlander 1 (2003-2008)
➤ Cooling system hoses Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Checking the tightness of the cooling system Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet