Electrical equipment of the car engine Mitsubishi Galant 6 and 7

General information about the engine electrical equipment
The electrical equipment of the engine includes components of the ignition, charging and starting systems. Due to the fact that these systems are directly related to the...

Engine Electrical Specifications
Ignition system General parameters Firing order/direction of rotation of distributor (except models with DIS) See Section Firing order Ignition coil Contactless ignition...

Removal and installation the battery
1. Starting with the negative, disconnect both cables from the battery. Warning! If the car stereo system is equipped with a security code, make sure you have the...

Checking the condition and replacing battery wires
Warning! If the car stereo system is equipped with a security code, make sure you have the correct combination to activate the audio system before disconnecting the...

Ignition System — General Information and Precautions
The models discussed in this Manual use two types of ignition systems: a contactless ignition system with a distributor and without one - a direct ignition system (DIS)....

Checking and adjusting the ignition system
Caution! Due to the very high voltage generated in the ignition system, its components must be serviced with extreme caution. This applies not only to the main...

Checking the condition and replacing the ignition coil
Contactless ignition systems with distributor Examination Models with ignition coil built into the distributor 1. Disconnect the negative cable from the battery....

Removal and installation the key transistor (ignition module)
Contactless ignition systems with distributor Engines 1.5 l, 1.8 l, 2.4 l and 3.5 l The key transistor is mounted in the ignition distributor, the description of the...

Removal and installation the ignition distributor (with contactless ignition system)
Removal 1. Bring the engine to the TDC position of the end of the compression stroke of the piston of the first cylinder, - be guided by the installation marks of the...

Firing order
Note: The efficiency of the output and the overall performance of the power unit depend on the correct sequence of ignition of the air-fuel mixture in the engine...

Charging system — general information and precautions
The components of the charging system include the alternator with its built-in voltage regulator, the charge indicator/check lamp, the battery, the protective fuses, and...

Checking the status of the charging system
1. Remember that charging system malfunctions are not necessarily related to generator failures. Always perform the following simple checks first: a) Check the condition...

Checking, removing and installing the generator
Generator Installation Details for 3.0L DOHC Models 1 - Drive belt; 2 - Assembling the generator with the support bracket; 3 - Support bracket; 4 - Generator Generator...

Starting System — General Information and Precautions
The system ensures the engine is turned over in order to start it. The main components of the system are the starter with a traction relay (magnetic starter) installed...

Checking the serviceability of the starter and starting circuit
Note: Before checking the starter condition, make sure the battery is fully charged. 1. If the starter does not rotate when the ignition key is turned to the START...

Removal and installation the starter
Removal 1. Disconnect the negative cable from the battery. Warning! If the car stereo system is equipped with a security code, make sure you have the correct combination...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Power unit: Engine electrical equipment Mitsubishi Colt 2 and 3 (1983-1993)
➤ Power unit: Engine electrical equipment Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Power unit: Engine electrical equipment Mitsubishi Carisma (1995-2004)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code