Car steering Mitsubishi Galant 6 and 7

Removal and installation the steering wheel
Mirage models up to 1993. Removal 1. Set the front wheels of the car to a straight position. Disconnect the negative cable from the battery. Warning! If the car stereo...

Removal and installation the steering column combination switch
Warning: Before performing any work near the air bag unit, steering column or instrument panel, turn off the SRS to avoid injury from accidental deployment (see Chapter...

Removal and installation the windshield wiper control switch
Note: On other models, this switch is built into the combined steering column switch assembly and is not serviceable individually. Removal 1. If the vehicle is equipped...

Removal and installation the ignition lock cylinder
Warning: Before performing any work near the air bag unit, steering column or instrument panel, turn off the SRS to avoid injury from accidental deployment (see Chapter...

Removal and installation the ignition switch
Mirage and Galant models Removal 1. Disconnect the negative cable from the battery. Warning! If the car stereo system is equipped with a security code, make sure you...

Removal and installation steering rods
Tie rod ends Removal 1. Disconnect the negative cable from the battery. Warning! If the car stereo system is equipped with a security code, make sure you have the...

Replacing the protective covers of the steering gear assembly
1. Loosen the nuts of the corresponding wheel. Jack up the front of the car and place it on supports. Remove the wheels. 2. Loosen the wheel nuts. Jack up the car and...

Removal and installation the manual steering gear
Manual Steering Gear Installation Details (Mirage Models) 1 - Bolt securing the steering column shaft to the rack and pinion drive pinion axle; 2 - Clamp; 3 - Cotter...

Removal and installation of power steering
Details of installation of hydraulic power steering on Galant models 1 - Tie bolt securing the lower steering column joint to the rack and pinion input shaft; 2 - Cotter...

Removal and installation the steering pump
Steering Pump Installation Details for Mirage Models 1 - Drive belt; 2 - Pressure sensor switch wiring connector; 3 - Suction hose; 4 - Pressure line; 5 - Sealing ring;...

Bleeding air from the hydraulic circuit of the power steering system
Front steering drive 1. Jack up the car and place it on supports. 2. Turn the steering pump pulley manually several times. 3. Turn the steering wheel from lock to lock...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Chassis and running gear: Steering Mitsubishi Colt 4 and 5 (1991-2003)
➤ Chassis and running gear: Steering Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Chassis and running gear: Steering Mitsubishi L200 4 (2005-2014, diesel)
➤ Chassis and running gear: Steering Mitsubishi Outlander 1 (2003-2008)
➤ Chassis and running gear: Steering Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Chassis and running gear: Steering Mitsubishi Space Star (1998-2005)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code