Car steering Mitsubishi Lancer 3 and 5

Steering wheel / steering column — device
1 - Lower instrument panel trim 2 - Decorative clip 3 - Air outlet nozzle 4 - Articulation bolt 5 - Horn button trim 6 - Steering wheel 7 - Lower steering column cover 8...

Steering gearbox
1 - Hinge connecting bolt 2 - Clamp 3 - Cotter pin 4 - Steering tip mounting nut 5 - Steering tip 6 - Steering gear housing clamp 7 - Steering gearbox

Removal and installation the steering wheel
Note: Designations in the text refer to Figure K-4001. Removal Set the wheels to the straight ahead position. Disconnect the ground cable from the battery. Caution: This...

Removal and installation the steering tip
Removal Loosen the wheel nuts on both front wheels while they are on the ground. Mark the position of the wheel disk on the wheel hub with paint. This ensures that the...

Removal and installation steering cuffs
Removal Remove the steering tip. Release the clamps at both ends of the cuff. Tighten the rubber cuff. Caution: As a result of long-term use of a defective cuff,...

Power steering — device
Power steering ensures the lowest possible effort when steering a vehicle. The power steering system consists of an oil pump, a compensation tank and a pipeline. The oil...

Checking the tightness of the steering system
If there is no fluid in the expansion tank, be sure to check the tightness of the steering system. Start the engine and let it idle. Turn the steering wheel in both...

Bleeding the steering system
Bleeding the steering system should be done when disconnecting the lines or after adding new fluid to the system. Caution: Do not reuse drained fluid. Always refill with...

Steering Wheel Vibration / Correcting Front End Imbalance
The cause of steering wheel vibration at certain speeds is usually wheel imbalance. Examination Check tire pressure and adjust if necessary. Take a test drive, determine...

Wheel alignment angles
Optimal driving characteristics and minimal tire wear are only achieved with correct front wheel alignment. If tires are excessively worn, if road holding is poor - if...

Installation and control values of wheel alignment angles
1) Cars produced from 9.86 to 8.88: Sedan with standard caster angle: 1° 00' ±30' Sedan with increased longitudinal tilt of the steering axis: 1° 40' ±30' Combi with...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Chassis and running gear: Steering Mitsubishi Colt 2 and 3 (1983-1993)
➤ Chassis and running gear: Steering Mitsubishi Galant 5 (1983-1989, petrol)
➤ Chassis and running gear: Steering Mitsubishi L200 4 (2005-2014, diesel)
➤ Chassis and running gear: Steering Mitsubishi Outlander 1 (2003-2008)
➤ Chassis and running gear: Steering Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Chassis and running gear: Steering Mitsubishi Carisma (1995-2004)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

Lancer 9 (2000-2007, petrol)