Share with friends:
Vehicle fuel system Mitsubishi Lancer 3 and 5
Fuel tank / fuel gauge — device
Top image: 13L petrol/1.8L diesel produced from May 1989 to March 1992 Bottom image: 1.5L petrol engine produced from May 1989 to March 1992 1 - Fuel tank cap 2 - Drain...
Top image: 13L petrol/1.8L diesel produced from May 1989 to March 1992 Bottom image: 1.5L petrol engine produced from May 1989 to March 1992 1 - Fuel tank cap 2 - Drain...
Ensuring cleanliness when working with the fuel system
When working with the fuel system, the following rules for ensuring cleanliness must be strictly followed: Thoroughly clean joints and surrounding surfaces before...
When working with the fuel system, the following rules for ensuring cleanliness must be strictly followed: Thoroughly clean joints and surrounding surfaces before...
Fuel level sensor
The sensor is located at the top of the fuel tank. As the fuel level decreases, the float also drops. At the same time, the sensor resistance, taken from the sensor...
The sensor is located at the top of the fuel tank. As the fuel level decreases, the float also drops. At the same time, the sensor resistance, taken from the sensor...
Removal and installation, checking of the fuel pump
Carburetor engine The fuel pump is mounted on the cylinder head. It is driven via the pump lever, directly from the camshaft. To check the fuel pump, it must be removed....
Carburetor engine The fuel pump is mounted on the cylinder head. It is driven via the pump lever, directly from the camshaft. To check the fuel pump, it must be removed....
Air filter
The picture shows the DOHC 1.6/1.8L engine. 1 - Battery 2 - Ventilation hose 3 - Air mass meter connector 4 - Air inlet hose 5 - Resonator (September 1990 - January...
The picture shows the DOHC 1.6/1.8L engine. 1 - Battery 2 - Ventilation hose 3 - Air mass meter connector 4 - Air inlet hose 5 - Resonator (September 1990 - January...
Removal and installation the air filter
Removal DOHC Engine: Disconnect the air mass meter connector. Gasoline engine: Disconnect the ventilation hose. Loosen the clamps on the air duct and air intake hose....
Removal DOHC Engine: Disconnect the air mass meter connector. Gasoline engine: Disconnect the ventilation hose. Loosen the clamps on the air duct and air intake hose....
Gas cable — device
The figure shows a 1.5L fuel injection engine. 2 - Set screw. On carburetor and diesel engines, there is a set nut with a lock nut instead. 4 - Cable end. Connection to...
The figure shows a 1.5L fuel injection engine. 2 - Set screw. On carburetor and diesel engines, there is a set nut with a lock nut instead. 4 - Cable end. Connection to...
Adjusting the throttle cable
Carburetor engine Check idle speed, see item. 7.4 / 8.4 . Turn off the ignition. Remove the air filter. Make sure there are no kinks in the gas cable. If not, replace...
Carburetor engine Check idle speed, see item. 7.4 / 8.4 . Turn off the ignition. Remove the air filter. Make sure there are no kinks in the gas cable. If not, replace...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar materials for other Mitsubishi models
➤ Power unit: Fuel system (diesel) Mitsubishi Colt 4 and 5 (1991-2003)
➤ Power unit: Fuel and exhaust system Mitsubishi Galant 5 (1983-1989, petrol)
➤ Power unit: Fuel system Mitsubishi L200 4 (2005-2014, diesel)
➤ Power unit: Fuel system (diesel) Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Power unit: Diesel supply system F9Q1 Mitsubishi Space Star (1998-2005)
Link in different formats to this section
TEXTHTMLBB Code
- General information
- User manual
- Maintenance
- Power unit
- Repair of MPI engines
- Repair of GDI engines
- Engine overhaul
- Cooling and lubrication system
- MPI fuel injection system
- GDI fuel injection system
- Intake and exhaust system
- Starting and charging system
- Transmission
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Doors, locks and windows
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Heater and air conditioner
- Security system SRS
- Equipment and devices
- Wiring diagrams (saloon)
- Wiring diagrams (wagon)
- General information
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Ignition system
- Fuel system
- Carburetor
- Fuel injection
- Diesel power system
- Exhaust system
- Transmission
- Clutch
- Car gearbox
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Heating system
- Electrical equipment
- Equipment and devices
- Power devices
- Electrical circuits