Car heater, ventilation and air conditioning Mitsubishi Lancer 9

Safety precautions during maintenance and repair
General information about refrigerant R-134a Since R-134a is a fluorinated hydrocarbon (HFC, in which chlorine atoms are replaced by hydrogen atoms), it does not have a...

Troubleshooting
Before replacing or repairing air conditioning system components, make sure there is a malfunction and check what it may be related to (refrigerant, air flow,...

Basic checks
Note: The procedures for checking the increased engine idle speed, adjusting the tension of the accessory drive belt and replacing the cabin filter are given in the...

Work with the air conditioning system
Air conditioning system refill 1. With the valve handles turned all the way out (valves closed), install the transition valve to the low pressure fitting of the...

Air Conditioner Control Panel Assembly
Removal and installation − The parts are removed in the order of numbers shown in the figure "Removing the air conditioner control panel assembly". Removal the control...

Heater unit and heater electric fan assembly
Removal and installation Caution: On vehicles with the SRS system, when removing and installing the heater unit, do not allow it to hit the SRS control unit or other...

Heater fan motor and air intake mode selection flap servo drive
Removal and installation − Before starting to remove parts, remove the glove box and the engine and CVT control unit. − The parts are removed in the order of numbers...

Evaporator assembly
Removal and installation − Before you begin removing parts, perform the following operations: a) Pump the refrigerant out of the air conditioning system. b) Remove the...

Compressor and drive belt for attachments
Removal and installation Note: Checking the compressor electromagnetic clutch is provided in the section " Basic checks ". - Before removing parts, pump out the...

Condenser and condenser fan motor
Removal and installation - Before removing parts, pump out the refrigerant from the air conditioning system. − Remove the parts in the order of the numbers shown in the...

Air conditioning system piping
Removal and installation Before you begin removing parts, perform the following operations: a) Pump the refrigerant out of the air conditioning system. b) Remove the...

Air ducts of the ventilation system
Removal and installation - If necessary, remove the instrument panel before starting to remove parts. Note: The procedure for removing the instrument panel is given in...

Differences for air conditioner with automatic etching
Reading and clearing fault codes Reading and deleting fault codes for the air conditioning system is only possible using a tester. The procedure for reading codes using...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Power unit: Heater and air conditioner Mitsubishi Colt 2 and 3 (1983-1993)
➤ Body and interior: Heating and air conditioning Mitsubishi Space Star (1998-2005)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

Lancer 9 (2000-2007, petrol)