MPI fuel injection system Mitsubishi Lancer 9

General rules when working with an electronic control system
Attention: Please read the section " Safety measures when performing work " chapters " Maintenance and general check and adjustment procedures ". Precautionary measures...

Fuel injection system diagnostics
General information 1. Type of self-diagnostic system. a) The models use a self-diagnostic system of the EOBD or OBD-II type, the standard diagnostic code of which...

Periodic maintenance
Bleeding residual pressure from the high-pressure fuel line Note: Since the fuel line is under pressure, perform this operation before removing fuel system components...

Checking the fuel injection system components (MPI)
Caution: The procedures for checking the exhaust gas recirculation (EGR) solenoid valve and the canister purge solenoid valve are given in the relevant section of the...

Checking Fuel Injection System Components with an Oscilloscope
Note: To connect the oscilloscope sensor (motor tester) to the sensor being tested, connect the test wire harness between the connectors (all terminals must be...

Car injectors
Removal and installation 1 Before removing parts, release residual pressure from the high-pressure fuel line. The parts are removed in the order of the numbers indicated...

Throttle body
Removal and installation − Before you begin removing parts, perform the following operations: a) Drain the coolant. b) Remove the air filter and air intake duct. − The...

Electronic engine control unit
Removal and installation − Before you begin removing parts, perform the following operations: a) Remove the glove box. b) Remove the wiring harness cover. − The parts...

Fuel tank
Removal and installation Before you begin removing parts, perform the following operations: a) Drain the fuel from the tank. b) Release residual pressure from the...

Accelerator pedal
Removal and installation − The parts are removed in the order of numbers shown in the figure "Removing the accelerator pedal". Removal the accelerator pedal. 1 -...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Power unit: Fuel injection MPI Mitsubishi Colt 4 and 5 (1991-2003)
➤ Power unit: Injection system (MPI) Mitsubishi Carisma (1995-2004)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

Lancer 9 (2000-2007, petrol)