Removal and installation
− Before you begin removing parts, perform the following operations:
- a) Remove the glove box.
- b) Remove the wiring harness cover.
− The parts are removed in the order of the numbers indicated in the corresponding figure.
Removal the throttle body (engine 4G93). 1 - accelerator pedal cable connection, 2 - throttle position sensor connector, 3 - idle speed control servo connector, 4 - vacuum hose connection, 5 - coolant hose connection, 6 - throttle body, 7 - throttle body gasket.
Removal the throttle body (engine 4G15). 1 - Accelerator pedal cable connection, 2 - Throttle position sensor connector, 3 - Idle speed control servo connector, 4 - Coolant hose connection, 5 - Vacuum hose connection, 6 - Throttle body, 7 - Throttle body gasket.
Removal the electronic engine control unit. 1 - electronic control unit connector, 2 - electronic control unit.
[Original material on the website MitsubishiMan.ru]
− Installation is carried out in the reverse order of removal.
- After completing the installation of the parts, perform the following operations:
- a) Install the wiring harness cover,
- b) Install the glove box.