Removal and installation
− Before you begin removing parts, perform the following operations:
- a) Drain the coolant.
- b) Remove the air filter and air intake duct.
− The parts are removed in the order of the numbers indicated in the figure "Removing the throttle body".
− Installation is carried out in the reverse order of removal
- When installing the parts, pay attention to the operation of installing the throttle body gasket.
Position the gasket so that its protruding part is located as shown in the figure.
- After completing the installation of the parts, perform the following operations:
- a) Install the air filter and air intake duct.
- b) Fill with coolant.
- c) Adjust the accelerator pedal cable.