Home Colt Lancer Galant L200 Outlander Pajero Others

Carisma (1995-2004) Space Star (1998-2005)

High Voltage Wire Inspection (MPI) (Mitsubishi Space Star)

0

When disconnecting the high-voltage wire tip from the spark plug, do not pull on the wire, but only on the tip, while turning the tip half a turn in one direction and the other.
Check the wire and cap insulation for cracks or damage.
Measure the resistance of all high-voltage wires, which should not exceed 22 kOhm (Fig. 9.4)

Fig. 9.4. Measuring the resistance of a high-voltage wire

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Miroslav Rakov

Share with friends:

◀ Previous

Space Star: Ignition system

Next ▶

Ignition coil with built-in power transistor
Power Transistor Test (MPI)
Checking the ignition coil (MPI)
Ignition system — technical data

Checking and cleaning spark plugs
Checking the misfire detection sensor
DOHC Engine Ignition Coils (GDI and 4G93-GDI)
SOHC Engine Ignition Coils (4G13-MPI)
Camshaft Position Sensor

Similar materials for other Mitsubishi models

➤ Checking the resistance of the high-voltage wire Mitsubishi Colt 5 (1995-2003, petrol)
➤ Checking High Voltage Wires (MPI Engine) Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Voltage Regulator/Generator Brushes — Replacement Mitsubishi Galant 5 (1983-1989, petrol)
➤ Combined switch for low and high beam headlights Mitsubishi L200 4 (2005-2014, diesel)
➤ Checking the voltage drop on the generator wire with the… Mitsubishi Outlander 1 (2003-2008)
➤ Checking high voltage wires Mitsubishi Pajero 1 and 2 (1982-1999)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

This resource sets cookies 🍪 to avoid bothering you with repeated data entry.