[Original version of the article on the website: MITSUBISHIMAN.ru]
[Original version of the article on the website: MITSUBISHIMAN.ru]
Checking the brake light switch (Mitsubishi L200 4)
Attach an ohmmeter to the switch terminals. The circuit should be open when the switch is pressed; closed - when released.
[Original version of the article on the website: MITSUBISHIMAN.ru]
[Original version of the article on the website: MITSUBISHIMAN.ru]
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article was reviewed by: Nikita Romanov
Share with friends:
Similar materials for other Mitsubishi models
➤ Checking the brake light switch Mitsubishi Colt 5 (1995-2003, petrol)
➤ Checking the brake light Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Replacing the brake light switch sensor Mitsubishi Galant 6 and 7 (1987-1998)
➤ Front fog light switch Mitsubishi Outlander 1 (2003-2008)
➤ Checking the brake light switch Mitsubishi Pajero 4 (2006-2021)
➤ Checking the brake light switch Mitsubishi Carisma (1995-2004)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Diesel engine
- Lubrication system
- Fuel system
- Control system
- Transmission
- Clutch
- Mechanical gearbox
- Transfer case
- Front axle
- Rear axle
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits