Checking the brake light switch (Mitsubishi Carisma)

Fig. 14.4. Checking the brake light switch

Connect a universal tester to the brake light switch and check the brake light switch circuit with the pusher pressed and released (Fig. 14.4). If the pusher is recessed so that its length is 4 mm from the end of the housing, then with a working switch the circuit should be open, with the pusher released - closed.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Dmitry Vasiliev

Share with friends:

◀ Previous

Carisma: Brake system

Next ▶

Checking and adjusting the brake pedal
General information about steering
Specifications and data

Checking the performance of the brake booster
Checking the functionality of the brake booster check valve
Checking the functionality of the rear brake pressure regulator
Checking the brake fluid level sensor
Bleeding air from the hydraulic brake drive

Similar materials for other Mitsubishi models