Car engine lubrication system Mitsubishi L200 4

Oil, pump, balance mechanism and oil pan
Oil, pump, balance mechanism and oil pan: 1. Oil filter; 2. Oil pressure sensor; 3. Heat exchanger mounting screw sealing ring; 4. Heat exchanger-oil cooler; 5. Heat...

Removal and installation the oil pressure sensor
Unscrew the sensor using the head and key (1). When installing the sensor, degrease the contact area (arrow). Apply 3M ATD #8660 sealant to the sensor threads as shown...
There is 1 comment

Removal the oil pan
1. Unscrew all the screws securing the tray. 2. Using a special cutter (1) (carefully moving it along the joint between the tray and the block), cut off the sealant and...

Removal and installation the flange screw for fastening the balance shaft gear
1. Remove the access plug on the right side of the cylinder block, insert a Phillips screwdriver into the resulting hole (to secure the shaft) and unscrew the mounting...

Disassembly and assembly of the oil pump
1. Loosen the mounting screws and remove the oil pump cover. 2. Mark the outer and inner rotors of the pump to ensure correct assembly later. When assembling, lubricate...

Replacing the rear bearing of the right balance shaft
The bearing is replaced using a special washer (1) (see Fig. M2 2.116), installed on the cylinder block and pullers (2 and 3) (see Fig. M2 2.117 and M2 2.118), as shown...

Installing the driven and driving gears and balance shaft seal
1. When installing the gears into the housing, lubricate them with engine oil and install them by aligning the marks (1). Installing the balance shaft seal 1. Place the...

Installing the crankshaft seals and front upper cover
Installing the crankshaft oil seal 1. Place a special guide sleeve (3) on the shaft, lubricating its outer surface with engine oil. 2. Using the mandrel (4), press the...

Installing the oil pan
The oil pan is installed on the gasket with the application of MITSUBISHI sealant No. MD970389 or similar. The pan must be installed no later than 15 minutes after...

Installation of heat exchanger
When installing the heat exchanger, position it as shown in the figure. Tighten the mounting screw to a torque of 39±5 Nm.

Installing an oil filter
1. Clean the surface of the adapter bracket. 2. Lubricate the surface of the sealing ring with a thin layer of engine oil. 3. Using a special attachment and a torque...

Inspection and testing of lubrication system parts
Front Bottom Cover The surface of the case must not have any cracks, chips or other damage. The oil pump rotors must rotate without jamming and have appropriate...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Power unit: Lubrication system Mitsubishi Colt 4 and 5 (1991-2003)
➤ Power unit: Lubrication system Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Power unit: Lubrication system Mitsubishi Pajero 4 (2006-2021)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code