Tighten the mounting screw to a torque of 39±5 Nm.
(The original material is posted on the website: mitsubishiman.ru)
Tighten the mounting screw to a torque of 39±5 Nm.
(The original material is posted on the website: mitsubishiman.ru)
Installation of heat exchanger (Mitsubishi L200 4)
When installing the heat exchanger, position it as shown in the figure.
Tighten the mounting screw to a torque of 39±5 Nm.
(The original material is posted on the website: mitsubishiman.ru)
Tighten the mounting screw to a torque of 39±5 Nm.
(The original material is posted on the website: mitsubishiman.ru)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article was reviewed by: Nikita Romanov
Share with friends:
Similar materials for other Mitsubishi models
➤ Cylinder Head Cover — Removal and Installation (All Engines) Mitsubishi Colt 4 and 5 (1991-2003)
➤ Removal and installation of a gasoline engine Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Removal and installation the heater heat exchanger Mitsubishi Galant 6 and 7 (1987-1998)
➤ Flushing the hydraulic line of the gearbox heat exchanger Mitsubishi Outlander 1 (2003-2008)
➤ Child seat — installation Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Flushing transmission fluid cooling heat exchanger tubes Mitsubishi Space Star (1998-2005)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Diesel engine
- Lubrication system
- Fuel system
- Control system
- Transmission
- Clutch
- Mechanical gearbox
- Transfer case
- Front axle
- Rear axle
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits