Attention! Before purchasing a child seat, check whether it will fit in the back seat of the car. Some child seats can be quite difficult to install due to the inappropriate positioning of the seat belt buckles. If the child seat slides forward easily, choose a different child seat.
Place the child seat in the center of the second seat in the vehicle.
Installation
1. Tighten the center seat belt to secure the child seat.
Please note: For safety reasons, the infant seat must be rear-facing and the toddler seat must be rear-facing.
2. Shorten the seat belt if necessary.
3. Check the reliability of the child seat attachment by trying to move it in all directions.
Installing a UNIBELT child seat (with shoulder and lower straps)
Statistics show that children are safer when they are wearing a child seat belt and are in the back seat rather than in the front seat. Therefore, we recommend that children be seated in the rear seat and buckled in when the vehicle is moving.
1. Install the child seat as shown in the illustration.
Please note: For safety reasons, the infant seat must be rear-facing and the toddler seat must be rear-facing.
2. Fully extend the seat belt. Then thread it through the child seat according to the seat manufacturer's instructions and insert the buckle into the lock. Check that the seat belt is tightened securely to ensure that the child seat is securely fastened. When you release the seat belt, it will tighten and the tightening device will switch to automatic operation. Once you remove the child seat and the belt is fully retracted into the drum, the tightening device will return to its original position.
Please note: For safety reasons, the infant seat must be rear-facing and the toddler seat must be rear-facing.
3. Check that the tightening device has been switched from emergency mode to automatic mode. In automatic mode, the tightening device always securely fastens the child seat.
Warning: If you do not set the tightening device to automatic operation, the child seat will not be securely fastened and will move forward in the event of braking or a minor accident.
Important: Follow the child seat manufacturer's instructions when installing the seat.
Caution: Make sure the seat belt is not twisted.
Installing a child seat in the front seat - models with UNIBELT seat belts
The installation of a child seat is described above. It is recommended that the child seat be installed in the rear seat of the vehicle with an adult sitting next to it. If the driver is the only adult in the vehicle, the child seat must be installed in the front seat and securely fastened.