Automatic transmission design Transmission MA904A (1983-86) 1. Torque converter; 2. Carter; 3. Front clutch; 4. Kick-down mode activation tape; 5. Rear clutch; 6. Leading casing; 7. Front planetary...
Automatic transmission controls adjustments Cars 1983-86 Adjustment of inclusion of a kick-down-mode Kick-down adjustment screw (M904A) The adjusting screw is located on the left side of the transmission case. 1....
Blocking switch — removal and installation Cars 1983-86 1. Disconnect the battery from the ground. 2. Remove the selector handle by pressing the button and loosening the screws. 3. Remove the central section,...
Interlock switch adjustment Cars 1983-86 1. Move the selector to the N position, tighten the mounting screws and check for a circuit between the BY–BY switch terminals (1 - initial position, 2 -...
Checking the adjustment of the transmission control cable 1. Engage the handbrake and depress the brake pedal. 2. Move the selector to position R. 3. Turn the ignition key to the START position. 4. Slowly move the selector to...
Transmission case shank oil seal 1. Disconnect the battery from the ground. 2. Raise the car. 3. Drain the liquid. 4. Mark the position of the flange of the cardan shaft and disconnect the shaft (see...
Removal and installation of transmission Automatic transmission KM148 (1987-89) 1. Handle; 2. Panel; 3. Cotter pin; 4. Axis; 5. Throttle cable; 6. High gear solenoid valve connector (overdrive valve); 7....