Intake and exhaust system of car Mitsubishi Pajero 4

Intake and exhaust system — general information
The intake manifold is cast from aluminum alloy. The shape of the intake manifold ensures better filling of the cylinders with air due to the inertial effect at the...

Checking and adjusting the exhaust system
1. Check the exhaust pipes, catalytic converter, muffler and resonator for damage, cracks, breaks and corrosion. 2. Check clamps, mounting brackets and insulators for...

Exhaust gas testing
1. Start the engine and set the crankshaft speed to 3000 rpm without load (neutral position of the gearbox) until the cooling fan starts to operate, and then reduce the...

Intake and exhaust system — equipment and tools
Drawing Name and code M.U.T.-III MB991953 Oxygen Sensor Removal Key

Removal the air filter
Model with 6G7 engine 1. Remove the air intake duct A (1). 2. Remove the air intake duct B (2). 3. Remove the breather connection (3). 4. Remove the air inlet hose (4)....

Installing an air filter
Model with 6G7 engine 1. Install the air filter bracket (14). 2. Install the air filter housing (13). 3. Install the air filter element (12). 4. Install the air filter...

Removal the intercooler
Model with 4M4 engine 1. Remove the air filter assembly. 2. Remove the lower support plate and engine crankcase guard. 3. Remove the radiator shroud cover. 4. Remove the...

Installing an intercooler
Model with 4M4 engine 1. Install the intercooler air pipe (6). 2. Install the reflector (5). 3. Install the intercooler assembly (4). 4. Install the air filter A2 of the...

Removal the intake manifold
Model with 6G7 engine 1. Reduce the fuel pressure in the fuel line. 2. Drain the coolant. 3. Remove the air filter assembly. 4. Remove the throttle body. 5. Remove the...

Installing the intake manifold
Model with 6G7 engine Note: When installing, tighten all bolts to the torques shown in the figure. 1. Install the intake manifold gasket (49). 2. Install the intake...

Removal the exhaust manifold
Model with 6G7 engine 1. Remove the engine cover. 2. Remove the lower support plate and engine crankcase guard. 3. Remove the front exhaust pipe. 4. Remove the battery...

Installing the exhaust manifold
Model with 6G7 engine 1. Install the exhaust manifold gasket (8). 2. Install the right exhaust manifold (7). 3. Install the right exhaust manifold cover (6). 4. Install...

Removal the exhaust pipe and muffler
Model with 6G7 engine (short wheelbase) 1. Remove the lower support plate and engine crankcase guard. 2. Remove the main muffler (1). 3. Remove the central exhaust pipe...

Installing the exhaust pipe and muffler
Model with 6G7 engine (short wheelbase) Note: Installation is carried out in the reverse order of removal. Note: Tighten the bolts to the torques shown in the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Power unit: Exhaust system Mitsubishi Colt 4 and 5 (1991-2003)
➤ Power unit: Intake and exhaust system Mitsubishi Lancer 9 (2000-2007, petrol)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

Pajero 4 (2006-2021)

Pajero 1 and 2 (1982-1999)