Car doors, locks and windows Mitsubishi Pajero 4

Removal the filler cap
Short wheelbase Long wheelbase 1. Remove the filler flap shock-absorbing spring (1). 2. Remove the rivet (2). 1) Make a hole in the rivet to break it using a drill with...

Installing the filler cap
1. Install the filler neck opening cable (6). 2. Install the rear floor air duct A (models with dual air conditioning). 3. Install the front body cross beam (left hand...

Front windshield
Removal the front windshield 1. Remove the front body trim. 2. Remove the front ceiling molding. 3. Remove the front pillar trim. 4. Remove the interior rearview mirror....

Rear square glass
Removal the rear square glass 1. Remove the rear upper square trim. 2. Remove the square glass rod (1). 3. Remove the rubber nut (2). 4. Remove the square glass (3)....

Rear windshield
Removal the rear windshield 1. Remove the tailgate upper trim, tailgate side upper trim and tailgate center trim. 2. Remove the rear wiper motor assembly. 3. Remove the...

Doors — technical operations on the car
Adjusting the door installation Attention: Attach protective fabric to the front fender and door edges where the awnings are installed. Do not turn the door hinge...

Checking the travel of the outer door handle
1. Check that the travel of the outer door handle is within acceptable limits. Nominal value (B): Front door: 11.4 mm. 2. If the travel of the outside door handle is not...

Door assembly
Removal the door assembly Short wheelbase 1. Remove the side trim of the hood. 2. Disconnect the electrical wiring connection (1). 3. Loosen the connecting bolt of the...

Door glass and window lift mechanism
Removal the door glass and window lift mechanism Front door 1. Remove the door trim and the inner door handle cover. 2. Remove the inner door handle. 3. Remove the...

Door handle and lock
Removal the door handle and lock Short wheelbase 1. Remove the door trim. 2. Remove the inner door handle (1). 3. Remove the water-repellent film. 4. Remove the door...

Glass guide
Removal the door guide Front door 1. Remove the inner door handle. 2. Remove the upper door catch holder. 3. Remove the door trim retaining bracket. 4. Remove the...

Luggage compartment door
Removal the tailgate 1. Remove the trunk lid spoiler. 2. Remove the upper trim of the luggage compartment door. 3. Remove the tailgate emblem. 4. Remove the tailgate...

Trunk door handle and lock
Removal the handle and lock of the luggage compartment door 1. Remove the upper trim of the luggage compartment door. 2. Remove the water-repellent film from the luggage...

Checking the hatch for leaks
Check the tightness of the hatch using the following procedure. 1. Close the hatch glass completely. 2. Adjust the water pressure so that the water jet rises to a height...

Adjusting the hatch installation
1. Close the hatch glass completely. 2. Open the sunroof curtain completely. 3. Loosen the screws that secure the sunroof glass assembly, and then slide the sunroof...

Hatch assembly
Removal the hatch 1. Remove the sunroof glass (1). 2. Remove the hatch switch cover (2). 3. Remove the sunroof switch (3). 4. Remove the ceiling trim. 5. Remove the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Body and interior: Doors, locks and windows Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Body and interior: Doors, locks and windows Mitsubishi Galant 6 and 7 (1987-1998)
➤ Body and interior: Doors, locks and windows Mitsubishi L200 4 (2005-2014, diesel)
➤ Body and interior: Doors, locks and windows Mitsubishi Outlander 1 (2003-2008)
➤ Body and interior: Doors, locks and windows Mitsubishi Carisma (1995-2004)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

Pajero 4 (2006-2021)

Pajero 1 and 2 (1982-1999)