Car front suspension Mitsubishi Pajero 1 and 2

Wheels — Checking and replacing
1. Nut 2. Wheel assembly 3. Cap The cars are equipped with wheels with cast or stamped steel disks. It is highly recommended not to install wheels other than those...

Torsion bar — removal and installation
Front suspension torsion bar 1. Case; 2. Torsion arm; 3. Torsion Removal 1. Raise the front of the vehicle. 2. Remove the wheel. 3. Raise the lower arm with a jack. 4....

Shock absorber — removal and installation
Upper Shock Mount Assembly Procedure (1992-98) 1. Lock nut 2. Nut Installing Remote Adjustable Shock Absorber Mounting Parts (1992-98) 1. Drive surface; 2. Nut; 3....

Upper ball joint of suspension
Checking, removing and installing 1. Remove the suspension arm and check the torque of the support, which should be 0.8–3.5 N·m. Otherwise, replace the support. 2. Raise...

Lower ball joint — removal, inspection and installation
Check on the car 1. Raise the front of the vehicle. 2. Disconnect the lower support (see below). 3. Screw on the support nut. 4. Check the torque of the support, which...

Anti-roll bar
Anti-roll bar mounting parts (1992-93) Removal procedure 1. Mud deflector; 2. Rack; 3. Clamp; 4. Bushing; 5. Stabilizer bar Anti-roll bar mounting parts (1994-95)...

Upper control arm — removal and installation
Removal 1.. Raise the front of the car, remove the wheel, fender protection panel and mud deflector. 2. Remove the shock absorber. 3. Raise the lower arm with a jack and...

Lower control arm and bushing replacement
Lower suspension arm 1. Shock absorber; 2, 12. Torsion arm; 3. Torsion; 4. Stabilizer bar; 5. Buffer; 7. Cotter pin; 8. Tightening ball joint; 11. Lever axis; 13. Lower...

Steering knuckle — removal and installation
The order of disassembling the fist 1. Seal; 2. Washer; 3. Needle bearing; 4. Fist; A. Lubricate Removal and installation 1. Unlock the hub by shifting the transfer case...

Front Wheel Bearing — Removal and Installation
Front wheel hub 1. Outer bearing; 2. Seal; 3. Inner bearing; 4, 5. Bearing races; 6. Brake disc; 7. Hub Removal bearing races from the hub 1. Outer bearing 2. Inner...

Wheel alignment angles
Front wheel alignment angles are checked and adjusted only in a car service center. Angle of longitudinal inclination of the axis of rotation If this angle is violated,...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar materials for other Mitsubishi models

➤ Chassis and running gear: Front suspension Mitsubishi Colt 4 and 5 (1991-2003)
➤ Chassis and running gear: Front suspension Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Chassis and running gear: Front suspension Mitsubishi Outlander 1 (2003-2008)
➤ Chassis and running gear: Front suspension and shafts Mitsubishi Carisma (1995-2004)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

Pajero 4 (2006-2021)

Pajero 1 and 2 (1982-1999)